eldoLED DUALdrive 1060/M Quick start guide

© 2013 eldoLED. All rights reserved. V2.5
More product documentation and eldoLED’s terms and conditions are available at www.eldoled.com.
Pay attention when connecting the LED groups:
• polarity reversal results in no light output and often damages the LEDs
• combining + and - of different groups damages the driver
2
1
LEDcode / NTC
+
-
N
L
VAC
120-277
{
+
-
+
-
DALI
{
9 mm
0.35 inch
0.5-1.5 mm2
AWG 20-16
2 LED groups,
1 control channel
{
2 LED groups,
1 control channel
{
Wiring diagram DUALdrive 1060/M (DL1060M1)
WARNING: Risk of electrical shock. May result in serious injury or death. Disconnect power before servicing or installing.
CAUTION: The device may only be connected and installed by a qualified electrician. All applicable regulations, legislation and build-
ing codes must be observed. Incorrect installation of the device can cause irreparable damage to the device and the connected LEDs.
120-277VAC
The driver accepts a universal mains voltage input of 120-277VAC,
50/60Hz.
DALI
Use these connectors to connect the driver to a DALI network. Always
combine a DA+ and DA- connector for either data input or data output.
LED wire length
Maximum wire length from LED driver to LED engine at full load:
LED groups
Indicates the location of the connectors for your LED groups. The four
LED groups are controlled over two control channels: DALI ballast 1
consists of LED group 1 and 2, and DALI ballast 2 consists of LED
group 3 and 4.
Output voltage vs output current for 4 outputs with symmetrical load
Vftyp is 57V, LED current ranges from 200mA - 1050mA
LEDcode/NTC
Use these connectors to connect a 47kΩNTC thermistor for closed
loop LED engine temperature control.
AWG value 20 19 18 17 16
Distance(m)1418222836
Distance (ft) 45.9 59 72.2 91.9 118.1
Please observe voltage drop over long wire lengths.
Longer wire lengths increase EMI susceptibility.
0
1050
420
200
830
0
60V
30V
mA
Vf


eldoLED Europe bv Luchthavenweg 18a 5657 EB Eindhoven The Netherlands T [phone] F [phone] [email protected]
eldoLED America, Inc. 1762 Technology Drive # 226 San Jose, CA95110 USA T [phone] F [phone] [e-mail]
Wiring diagram DUALdrive 1060/M (DL1060M1)
Connecting 3 LED groups
Output voltage vs output current for 3 outputs with symmetrical load
Vf typ is 57V, LED current ranges from 200mA - 1050mA
Connecting 2 LED groups
Output voltage vs output current for 2 outputs with symmetrical load
Vf typ is 57V, LED current ranges from 200mA - 1050mA
Connecting 1 LED group
Output voltage vs output current for 1 output
Vf typ is 57V, LED current ranges from 200mA - 1050mA
0
1050
550
200
0
60V
30V
mA
Vf
3 outputs, 100W,

0
1050
200
830
0
60V
30V
Vf
mA
2 outputs, 100W, 
0
1050
200
0
60V
30V
mA
Vf
1 output, 60W