Eleiko 3085354 User manual

INSERT PLATFORM FOR
ELEIKO XF 80 HOME RACK
Art.no. 3085354

CAUTION
The equipment must be installed and used in a place whose access and supervision
are specifically controlled by the owner.
Be sure to install the equipment on a stable base and properly level the equipment.
ELEIKO recommends that all equipment is secured to floor and installed by a licensed
contractor or an ELEIKO-installer.
SAFETY INSTRUCTIONS
It is the responibility of the purchaser of ELEIKO products to instruct all users and
supervising personnel on proper usage of the equipment.
1. All included warnings (labels) and instructions MUST be read before the use of any
ELEIKO-equipment. Use each equipment as it is intended for.
2. A user MUST get a medical examination and proper instructions before the use of
any ELEIKO-equipment.
3. DO NOT let anyone, under any cuircumstances, use equipment that appears to be
damaged. Do not try to repair any equipment before consulting an ELEIKO technician.
4. DO NOT replace the components of ELEIKO-equipment with other none ELEIKO-
equipment (magnetic safety pin, frames, bars), do not improvise. If there are any
doubts consult an ELEIKO representative prior to any intervention.
5. DO NOT overload the equipment and DO NOT try to exceed personal strength
levels.
6. Children under the age of 14 must be supervised by an adult.
7. DO NOT remove any safety labels from the ELEIKO-equipment. ELEIKO is not
responsible if a label is removed. Replace damaged labels immediately.
PREVENTITIVE MAINTENANCE & INSPECTIONS
REGULARLY:
Clean the surfaces on frames and tubes from dust and dirt.
Check that all bolts between parts, walls, floors are properly tightened, according to
recommendations.
Check equipment for sharp edges and replace if necessary.
Check tubes for cracks or other defects, replace if necessary.
WARRANTY
All products manufactured by ELEIKO are warranted to the original purchaser to be
free from defects in workmanship and / or materials under normal use or service as
follows:
Tubing and corners: 10 years
Wooden deck, rubber tiles: 1 year
Normal wear and tear does not fall under the warranty.
ADDITIONAL INFORMATION
This equipment is for indoor use only.
READ BEFORE INSTALLATION AND USE

2446
2070
1000
1000 1000
Insert platform for XF 80 Home Rack
Add sufficient
clearance, not less
than 1,0 m, on all
sides.
Product weight 100 kg / 220 lbs
Dimensions (L x W x H)
2445x2070x30 mm
96,3x81,5x1,2 inch
PRODUCT SPECIFICATIONS
FOOTPRINT AREA

3085381 2000404
x2
3001384-04
x6 x8
3001384-03
x2
3001745p4
x32
2000747-L12
2001191p1
Square tube
30x30x2 L=996
2000379 p2
Square tube
30x30x2 L=691
2000375 p1
Square tube
30x30x2 L=968
2001191p2
Square tube
30x30x2 L=996
2000379 p1
Square tube
30x30x2 L=691
x2
2000375 p6
Square tube
30x30x2 L=988
2000379 p8
Square tube
30x30x2 L=2368
CONTENTS

Allen Key
size 5
The table below is general torque to use for different
threads. Use these torques, if nothing else is set. Below
numbers are for screw/nut of quality 8.8.
THREAD
TORQUE (Nm / ftlb)
Quality 8.8
M8 24 / 17,7
REQUIRED TOOLS
GENERAL

OO
M
x6
P
O-O (1 : 50)
5
Corner
Screw
Bracket
x24
2000747-L12
x6
3001384-03
3001384-04
x6
1.
Loose screws!
ASSEMBLY INSTRUCTIONS

C
D
x2
3001384-03
x2
3001745p4
x8
2000747-L12
2.
x2
Loose screws!

3085381 2000404
x2
3.

2000375 p1
2001191p1 2001191p2
2000379 p22000379 p1
2000375 p6
2000375 p6
2000379 p8
2001191p1
Square tube
30x30x2 L=996
2000379 p2
Square tube
30x30x2 L=691
2000375 p1
Square tube
30x30x2 L=968
2001191p2
Square tube
30x30x2 L=996
2000379 p1
Square tube
30x30x2 L=691
x2
2000375 p6
Square tube
30x30x2 L=988
2000379 p8
Square tube
30x30x2 L=2368
4.

J
5.

J
6.

Eleiko Group AB | Klastorpsvägen 18 | SE-302 62 HALMSTAD | Sweden
E-mail: [email protected] | Phone: [phone]
www.eleiko.com
rev. 2014