Elite Screens Insta-DEM Series User manual

Insta-DEM Series
Magnetic Dry-Erase Front Projection Screen
User’s Guide
What’s in the package
Please make sure all parts listed below are included. I f a n y t h i n g i s m i s s i n g p l e a s e c o n t a c t u s
i m m e d i a t e l y .
a. b. c. d. e. f.
Notes:
1. For best results and maximum product longevity, ONLY use Elite Screens high density whiteboard Eraser
2. Please use the microfiber cloth and clean water to cleanse the surface every 2-4 weeks to maintain a fresh
and clean projection surface.
071213-JA www.elitescreens.com 1
Parts List
QTY
a. Insta-DEM Screen Material
1
b. Pen Holder
1
c. Magnetic bar
2
d. Whiteboard markers
3
e. Elite special high density eraser
2
f. Microfiber cleaning cloth
1

Installation
Attention: Prolonged storage of the Insta-DEM in its factory packaging may result in the material not being able
to lie flat once removed from its tube. An easy way to remedy this is to remove the material from the tube and
roll it up in a reverse manner for 5 minutes. This will flatten out the material and make it more pliable to work
with.
1. Clean the magnetic surface location w h e r e the Ins t a -DEM Scre en will be installed.
2. Measure and mark the top-right and bottom-right corner of the installation location.
3. Attach the Insta-DEM Screen to the top-right and bottom-right corner of the magnetic surface location
as shown below.
4. Carefully unroll the material and firmly attach the top and bottom until the Insta-DEM Screen is
completely attached to the magnetic surface.
071213-JA www.elitescreens.com 2
Magnetic surface
Wall
Magnetic
Surface

5. Secure the edges by placing the magnetic bar on the left and right side of the Insta-DEM Screen.
This allows the material to lay flat on the magnetic surface.
Note:
The magnetic bars can be removed once the Insta-DEM screen material is securely attached to the
magnetic surface.
6. Peel the tape strip off the back of the pen holder and attach the pen holder to the wall or your
preferred location.
Use only the included erasers to remove and erase dry-erase markings. For a deep clean, we
recommend using a non-alcohol based dry-erase board cleaner with a soft microfiber cloth.
Elite offers a replacement kit (part number ZER3) which includes:
1 x bottle of 8.45 oz cleaning solution
1 x microfiber cloth
2 x high density foam erasers
2 x sets of dry-erase markers (4 total)
Contact your reseller or visit shop.elitescreens.com for pricing and purchase.
For more information, technical support or your local Elite Screens contact,
please visit www.elitescreens.com
071213-JA www.elitescreens.com 3
Wall
Pen holder
Magnetic bar