Elite Screens OMS125HLITE User manual

Rev.11162021JA www.elitescreens.com 1
Yard Master Lite Series
Ultra-Portable Outdoor Projector Screen
User’s Guide
125”(16:9)
Visit www.elitescreens.com/ymlite-assemble or
Scan QR code for our how to assemble video

Rev.11162021JA www.elitescreens.com 2
Warning
▪The warranty will only be valid if screen is used for its intention. Misuse, abuse,
negligence, accidental damage, or damages caused by environmental factors are not
covered under warranty.
▪Improper use and operation may cause serious injury and / or damage to the screen,
use only as directed.
▪Do not use in environments with winds speeds more than 4 MPH.
▪To prevent damage, the operation and maintenance of the screen should be done by
adults only.
▪Make sure the surface for placing the screen is flat and secure.
▪Please read the following as any damage to the screen surface will impact the image’s
quality:
1. Avoid touching the screen’s viewing surface are with your hands.
2. Do not write or draw on the screen surface.
3. Do not poke the screen surface with your finger or sharp tools, as it can cause permanent
damages or tearing of the fabric.
Ignoring the safety warnings may lead to
injuries and damaging the product.
The screen should be installed in a secure
and stable place to avoid any accidents or the
screen falling.
Put the screen away after every use.
Leaving the screen for a long period may
cause the screen fabric to sag.
Avoid hanging anything on the screen as it
may cause the screen to fall and damaging
the product.
Do not replace with unknown parts, if
replacement parts are needed, please
contact [e-mail]
Parts List
Product specifications are subject to change.

Rev.11162021JA www.elitescreens.com 3
Assembly
Join 4x “A” tubes with the straight joint “D” to
assemble each top/bottom crossbar.
Join 2 x “B" tubes and 1 x “C"
tube together using a straight
joint “D” and a T-joint “F” to
assemble the left/right sides.
Put a top/bottom crossbar through the upper side of the material.
Note:
Top side has
tethering loops

Rev.11162021JA www.elitescreens.com 4
B
B
Insert the L/R sides through the material and secure to the joints.
Attach and secure the joints at both ends of the top/bottom crossbars.
Note:
Use the tethering rope and
stakes to stabilize the screen
on grass or soil ground.
4 stakes used on base and 4
stakes used on tethering
ropes.
Water bags can also improve
stability and prevent screen
from falling.
Insert the L/R sides to the base and secure with the pins.
Assembly is complete.

Rev.11162021JA www.elitescreens.com 5
Disassembly
Remove the stakes from the tethering ropes and base. Then remove
the tethering ropes from the screen.
Remove the pins, pull
out the L/R posts from
the base and remove the
water bags.

Rev.11162021JA www.elitescreens.com 6
B
B
D
B
B
Disassemble the L/R posts
by disjointing the straight
and T-joints.
F
D
F
C
C
Remove the elbow joints at both ends of the top crossbar and
slide both top/bottom crossbars out of the screen.
A
A
A
Disassemble the Top/Bottom posts by disjointing the straight joints.