Elkay FLEXI-GUARD ESRC8,13 1D Series Installation manual

97079C (Rev. C - 5/98)
ESRC8,13*1D ESRC13*2D,3D
PAGE 1
With FLEXI-GUARD®
Installation/Care/Use Manual
USES HFC-134A REFRIGERANT
FIG. 1
SEE FIG. 3
SEE DETAIL
ABOVE
26
6
2
45
8 - See Fig. 4
44
7
14
43
18
15, 16
& 17
28
25
39
13
23
46
22
31
32
29
30
127
19, 20
& 21
3, 4, 5
41
24
47
42
40
48

97079C (Rev. C - 5/98)
ESRC8,13*1D ESRC13*2D,3D
PAGE 2
FIG. 2
* RECOMMENDED HEIGHT FOR ADULTS.
DECREASE HEIGHT FOR CHILDREN.
* ALTURA RECOMENDADA PARA ADULTOS.
REDUZCA PARA LOS NIÑOS.
* HAUTEUR RECOMMANDÉE POUR LES
ADULTES. INSTALLEZ PLUS BAS POUR LES ENFANTS.
FINISHED FLOOR PISO ACABADO PLANCHER FINI
MOUNTING BOX
SHIPPING POSITION OF FASTENING CLIP
COOLER BASE
POSITION FASTENING CLIP AS SHOWN AFTER COOLER IS HUNG IN PLACE
DETAIL A
DETAIL B
SEE DETAILS A & B
MOUNTING BOX
ROUGH-IN
D = ELECTRICAL OUTLET LOCATION
UBICACIÓN DE LA TOMA DE ELECTRICIDAD EMPLACEMENT DE LA PRISE DE COURANT
E = INSURE PROPER VENTILATION BY MAINTAINING 4" (102mm) (MIN.) CLEARANCE FROM CABINET LOUVERS TO WALL.
ASEGURE UNA VENTILACIÓN ADECUADA MANTENIENDO UN ESPACIO E 4" (102mm) (MÍN.) DE HOLGURA ENTRE LAREJILLADE VENTILACIÓN DEL MUEBLE Y LA PARED ASSUREZ-VOUS UNE BONNE VENTILATION EN GARDANT 4" (102mm) (MIN.) ENTRE LES ÉVENTS DE LENCEINTE ET LE MUR.
F = POWER CORD 1-1/2FEET (457mm) LONG
CABLE ELÉCTRICO DE 1½ PIE, 457 mm DE LARGO CORDON DALIMENTATION 1-1/2' (457mm)
LEGEND/LEYENDA/LÉGENDE A = RECOMMENDED WATER SUPPLY LOCATION 3/8 O.D. UNPLATED COPPER TUBE CONNECT STUB 1-1/2 IN. (38 mm) OUT
FROM WALL SHUT OFF BY OTHERS SE RECOMIENDA UBICAR EL TUBO CORTO DE CONEXIÓNALTUBO DE COBRE SIN CHAPAR DE 3/8" DE DIÁM. EXT. A1-1/2"
(38 mm) FUERA DE LALLAVE DE PASO EN LA PARED COLOCADA POR TERCEROS.
EMPLACEMENT RECOMMANDÉ D'ALIMENTATION EN EAU PAR TUBE EN CUIVRE NON PLAQUÉ DE 3/8 PO. (9,5 mm) D.E.
CONNECTANT UNE TUYAUTERIE DE 1-1/2 PO. (38 mm) DEPUIS LE ROBINET D'ARRÊT FOURNI PAR D'AUTRES.
B = RECOMMENDED LOCATION FOR WASTE OUTLET 1-1/4 O.D. DRAIN
UBICACIÓN RECOMENDADA PARA EL DRENAJE DE SALIDADE AGUA, DE 1¼ DE DIÁMETRO. EMPLACEMENT RECOMMANDÉ POUR LE DRAIN DE D.E. 1-1/4" DE SORTIE DEAU.
C = 1-1/4 TRAP NOT FURNISHED**
PURGADOR DE 1¼ NO PROPORCIONADO** SIPHON 1-1/4 NON FOURNI**

97079C (Rev. C - 5/98)
ESRC8,13*1D ESRC13*2D,3D
PAGE 3
FIG. 3
Stream height is factory set at 35 PSI. If supply pressure varies greatly
from this, remove items 33 & 34 and adjust screw on item 36. Clockwise
adjustment will raise stream and counter-clockwise adjustment will lower
stream. For best adjustment, stream should hit basin approximately 6-1/2"
(165mm) from bubbler.
NOTE:
WHEN INSTALLING REPLACEMENT BUBBLER
AND PEDESTAL, TIGHTEN NUT (ITEM 12) ONLY
TO HOLD PARTS SNUG IN POSITION.
DO NOT OVER TIGHTEN.
BASIN
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON
INSTALLATION OF COOLER
4) Hang the cooler on the hanger brackets. Be certain the hanger brackets are engaged properly in the frame and wrapper.
5) Remove the access panel on the underside of the cooler and set it aside.
6) Connect water inlet line--See Note 4 of General Instructions.
7) Remove the slip nut and gasket from the trap and install them on the cooler waste line making sure that the end of the waste line fits into the
trap. Assemble the slip nut and gasket to the trap and tighten securely.
START UP
Also See General Instructions
8) Replace the front panel and secure by retightening all screws.
FIG. 4
10
11
12
89
WRAPPER
36
34
35
33 37 38
HANGER BRACKETS AND TRAP INSTALLATION
1) Remove hanger brackets fastened to back of cooler by removing screws.
2) Mount the hanger brackets and trap as shown in Figure 2.
NOTE: Hanger brackets and trap MUST be supported securely. Add fixture support carrier if wall will not provide adequate support.
IMPORTANT:
 5-1/2 in. (140mm) dimension from wall to centerline of trap must be maintained for proper fit.
 Anchor hanger securely to wall using all six (6) 1/4 in. dia. mounting holes.
3) Install straight valve for 3/8 in. O.D. unplated copper tube.

97079C (Rev. C - 5/98)
ESRC8,13*1D ESRC13*2D,3D
PAGE 4
PARTS LIST 115V
ITEM NO. PART NO. DESCRIPTION
31504C
27321C
30699C
70018C
31490C
70009C
50186C
51349C
40322C
50934C
50168C
70012C
62152C
66202C
50144C
70184C
70418C
35767C
35947C
194243901550
31025C
31039C
35766C
35768C
66223C
66501C
40041C
40429C
50074C
20593C
70208C
31513C
62220C
55996C
70772C
70767C
27239C
40089C
40048C
15005C
61313C
40169C
50986C
See Color Table
40038C
40619C
50105C
27093C
27292C
27331C
27258C
40043C
35935C
Power Cord
Fan Bracket
Fan Blade
Hex Nut - Fan Blade
Fan Motor
Screw (Fan Motor)
Shroud - Fan
Bubbler Assy
Orifice Assy
Housing Assy
Pedestal
Locknut
Condenser
Drier
Grommet - Compressor Mtg.
Hair Pin - Cotter
Washer
Compressor Serv. Pak FF7.5HBK
Compressor Serv. Pak EM65
Cover - Electrical Shield (Overload)
Overload/Relay 1.350.358
Overload/Relay P600B/427NFBYY
Cover - Relay
Cover - Relay
Heat Exchanger
Heat Exchanger
Tailpipe Assy (8 Gal)
Precooler Assy (13 Gal)
Tailpipe Gasket
Basin - Stainless Steel
Screw - Basin Mtg.
Cold Control
Evaporator Assembly
Strainer
Drain Plug
Evaporator Retaining Clip
Bracket - Precooler
Cover
Button
Retaining Nut
Regulator
Hex Nut
Regulator Holder
Wrapper
Strainer - Beehive
Ferrule - Tailpipe
Tailpipe Gasket
Angle-Front Corner
Bracket-Basin Mounting
Frame-Back/Bottom
Bracket-Front
Locknut
Capacitor - Run
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18*
18a*
19
20
20a
21
21a
22
22a
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48a
ELKAY MANUFACTURING COMPANY  2222 CAMDEN COURT  OAK BROOK, IL 60523  630.574.8484
PRINTED IN U.S.A.
220/240v 50Hz
31430C
35763C
31024C
Fan Motor
Compressor Serv. Pak
Overload/Relay Assy.
PART. NO. DESCRIPTIONITEM NO.
220/240v 60Hz
31431C
35842C
Fan Motor
Compressor Serv. Pak
PART. NO. DESCRIPTIONITEM NO.
5
18*
20
5
18*
*INCLUDES RELAY & OVERLOAD. IF UNDER WARRANTY, REPLACE
WITH SAME COMPRESSOR USED IN ORIGINAL ASSEMBLY.
NOTE: All correspondence pertaining to any of the above water coolers
or orders for repair parts MUST include Model No. and Serial No. of cooler,
name and part number of replacement part.
COLOR TABLE
PANEL COLOR Item No. 39
Part No.
Gray Beige
Almond
Stainless Steel
Sandalwood
Granite
21017C
21481C
21013C
21480C
27208C
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620