E+E Elektronik EE150 User manual

SCOPE OF SUPPLY
• Foraccuratemeasurementitisessentialthatthetemperatureoftheprobeandmainlyofthesensingheadissameasthe
temperatureoftheairtomeasure.
• AvoidmountingtheEE150transmitterinawaywhichcreatestemperaturegradientsalongtheprobe.Ifpossible,EE150shall
beinstalledwiththeentireprobeinsidetheduct.Forinstallationwithmountingflange,incaseofdifferenttemperatureinside
andoutsidetheduct,theprobepartoutsidetheductshallbethermallyisolated.
• Thedeviceandmainlythesensingheadshallnotbeexposedtoextrememechanicalstress.
• Donotattempttoremovethefilercap,whichisfixed.Avoidtouchingthesensingheadatalltimes.
• ThestainlesssteelprobeisESDsensitiveandshallbehandledassuch.Donotconnectittothegroundpotential.
CAUtiOn
USER‘S GUIDE
COnnECtiOn diAgrAm
EE150 - Humidity and Temperature Transmitter for HVAC applications
5
6
(class III)
(class III)
T-passive connection
for HT3xxx/HT6xxx
EE150-HT3xxx
EE150-HT6xxx
dimEnSiOnS / mOUnting
CABLE GLAND M16x1.5
80.8 (3.18)
56 (2.2)
63 (2.48)
55.3 (2.18)
39.5 (1.56)
ø 5 (ø 0.2)
ø 4 (ø 0.16)
ø 6
(ø 0.24)
ø 7
(ø 0.28)
42 (1.65)
28.55
(1.12)
200
(7.87)
drilled hole for
mounting: ø>9 (ø>0.35)
Dimensions: mm (inch)
setupandadjustmentinterface(withEE-PCA)
setupandadjustmentinterface(withEE-PCA)
• EE150transmitter,typenumberaccordingtoorder(fororderingguideseedatasheetatwww.epluse.com/EE150)
• CableglandM16x1.5
• Mountingflange,PC,Ø6.0mm
• TestreportaccordingtoDINEN10204–2.2

tECHniCAL dAtA
(Modification rights reserved)
INFORMATION [phone] / inf[email protected]
Langwiesen7•A-4209Engerwitzdorf
Tel:+437235605-0•Fax:+437235605-8
[email protected]•www.epluse.com
LGLinzFn165761t•UID-Nr.ATU44043101
PlaceofJurisdiction:A-4020Linz•DVR0962759
BA_EE150_e//v1.0//TechnischeÄnderungenvorbehalten
TheEE150isreadytouseanddoesnotrequireanycongurationbytheuser.ThefactorysetupofEE150correspondstothetypenum-
berordered.Fororderingguidepleaseseedatasheetatwww.epluse.com/EE150.
Ifneeded,theusercanchangethefactorysetupbyusingtheoptional E+E Product ConfigurationAdapter (EE-PCA) and the E+E
ProductConfigurationSoftware(EE-PCS).Withthese one can set the output scaling, and perform one or twopointadjustmentfor
humidityandtemperature.
ForproductdatasheetEE-PCApleaseseewww.epluse.com.
TheE+EProductConfigurationSoftware(EE-PCS)isfreeandcanbedownloadedfromwww.epluse.com/configurator.
SEtUP And AdJUStmEnt
USA
FCC notice:
ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuanttopart15oftheFCCRules.Theselimitsare
designedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstallation.Thisequipmentgenerates,usesandcanradiatera-
diofrequencyenergyand,ifnotinstalledandusedinaccordancewiththeinstallationmanual,maycauseharmfulinterferencetoradiocommunications.
However,thereisnoguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoescauseharmfulinterferencetoradioor
televisionreception,whichcanbedeterminedbyturningtheequipmentoffandon,theuserisencouragedtotrytocorrecttheinterferencebyoneor
moreofthefollowingmeasures:
- Reorientorrelocatethereceivingantenna.
- Increasetheseparationbetweentheequipmentandreceiver.
- Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
- Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
CANADIAN
ICES-003 Issue 5:
CANICES-3B/NMB-3B
Measured values
Relative Humidity
 Workingrange 10...90%RH
 Accuracyat20°C ±3%RH(30...70%RH),otherwise±5%RH
 Temperaturedependency typ.±0.05%RH/°C
Temperature
 Workingrange -5...55°C(23...131°F)
 T-Accuracyat20°C ±0.3°C
Outputs
Analog output 0-10V RL≥10kOhm
 (0...100%RH;T:seeorderingguide) 4-20mA(2-wire) RL≤500Ohm
Passive T-sensor
 2-wire seeorderingguide
 Wiresresistance(terminal-sensor) typ.0.5Ohm
General
Powersupply(ClassIII)
 for0-10V 15-35VDCor24VAC±20%
 for4-20mA 10V+RLx20mA<UV<35VDC
 Currentconsumption withDCpowersupply typ.5mA
  withACpowersupply typ.13mAeff
 Connection Screwterminals,max.1.5mm2
 Housingmaterial Polycarbonate,UL94V-0approved
 Protectionclass IP65/NEMA4
 Cablegland M16x1.5
 Sensorprotection PTFEfilter,non-removable
 Electromagneticcompatibility EN61326-1EN61326-2-3Industrialenvironment
   FCCPart15ClassBICES-003Issue5ClassB
 Workingconditions -5...55°C (23...131°F) 0...95%RH(non-condensing)
 Storageconditions -25...60°C(-13...140°F) 20...80%RH