Epson SC-P8500D Series User manual

2-inch Core/3-inch Core Loading the Roll Paper on the Spindle
When using a 2-inch core
Remove the core adapters from
the media edge guide on both
sides.
When using a 3-inch core
Attach the core adapters to
the media edge guide on both
sides.
1
Insert the spindle with the roll paper
facing the direction shown in the
illustration.
2
Attach the media edge guides so that
there are no gaps between them and
the roll paper.
CMP0347-00 EN
© 2021 Seiko Epson Corporation

Loading Roll 1 Removing Roll 1
1Set the paper support to the
position shown in the illustration. 3Lower the spindle lock lever.
2Place the spindle into the grooves
with the black media edge guide
on the right.
1Eject the roll paper. 3Remove the spindle.
2Raise the spindle lock lever.

Loading Roll 2
1Set the paper support to the position
shown in the illustration. 3Pull out the roll2 unit. 5Return the roll2 unit.
2Raise the spindle lock lever. 4Place the spindle into the grooves with
the black media edge guide on the right. 6Lower the spindle lock lever.

Removing Roll 2
1Eject the roll paper. 3Pull out the roll2 unit. 5Place the spindle into the grooves
with the black media edge guide
on the right.
7Lower the spindle lock lever.
2Raise the spindle lock lever. 4Remove the spindle. 6Return the roll2 unit.

Loading Cut Sheets/Poster Board (Front) Loading Cut Sheets/Poster Board (Back)
Make sure there is enough space at the
front/back of the printer.
Load poster board vertically.
4Align the paper with the
alignment position on the right
side with the side to be printed
facing up.
1Select [Menu] - [General Settings]
- [Printer Settings] - [Paper Source
Settings] - [Cut Sheet/Poster
Board Slot] - [Front].
2Select [Paper Setting] - [Cut Sheet]
or [Poster Board].
Choose a paper type that matches
the paper in the printer.
3Set the paper support to the
position shown in the illustration. 5Insert the paper straight into the
printer to the position shown in
the illustration.
Make sure there is enough space at the
front/back of the printer.
Load poster board vertically.
4Go to the rear of the printer, align
the paper with the alignment
position on the left side with the
side to be printed facing up.
1Select [Menu] - [General Settings]
- [Printer Settings] - [Paper Source
Settings] - [Cut Sheet/Poster
Board Slot] - [Back].
2Select [Paper Setting] - [Cut Sheet]
or [Poster Board].
Choose a paper type that matches
the paper in the printer.
3Set the paper support to the
position shown in the illustration. 5Insert the paper straight into the
printer to the position shown in
the illustration.

Replacing Ink Cartridges Replacing Maintenance Box
1
Shake the ink cartridge for 10
seconds 30 times horizontally in
approximately 10 cm movements
as shown in the illustration.
3Place your nger into the gap and
remove the ink cartridge.
2
Open the ink cartridge cover.
4Push the ink cartridge in rmly.
5
Close the ink cartridge cover.
1Open the maintenance box cover. 3Carefully insert the new
Maintenance Box.
2Pull out Maintenance Box. 4Close the maintenance box cover.