Epson Stylus CX5500 Series User manual

User’s Guide
— for use without a computer —
Loading Paper
Placing an Original
Copying
Replacing Ink Cartridges
Open Close
Copying Without Borders
Reducing Photos
Copying Documents
Making Draft Copies
or
Enlarging Documents
+
Cancel Copy
or
+
Hold ybutton and press xbutton
Press for three seconds
Press
Install Click
Close (Click)
Close
Press
Open
The _mark
indicates a
low or
expended
ink cartridge.
Remove
Repeat this step to check other cartridges.
Checking the Ink Cartridge Status
Removing and Installing Ink Cartridges
Epson Ink Cartridges
Color Part Number
Black T0731/T0911
Cyan T0732/T0912
Magenta T0733/T0913
Yellow T0734/T0914
Press
Flashing quickly On
Wait about 1 min
Shake Unpack
Only remove
the yellow tape
Note:
Do not open the ink cartridge package until you are ready to install it in the printer.
The cartridge is vacuum packed to maintain its reliability.
Open
Copyright © 2007 Seiko Epson Corporation. All rights reserved.
Printed in XXXXXX XX.XX-XX XXX
Loading Capacity
Available Paper Paper Size Sheets
Plain Paper
A4 80
Epson Premium Ink Jet
Plain Paper
Epson Bright White Ink
Jet Paper
Epson Premium Glossy
Photo Paper
10 ×15 cm
(4 ×6 in.) 20
Epson Premium
Semigloss Photo Paper
Epson Glossy Photo
Paper
Epson Ultra Glossy
Photo Paper

Troubleshooting
Error Indicators
Copy Problems
Lights Cause Solution
&See Loading Paper on the front page.
Prepare a new ink cartridge.
Other lights off
Sleep mode Press any button except the button to wake the product.
or
or
&See Replacing Ink Cartridges on
the front page.
If the light is still on or flashing after you replace the cartridge, try the
procedure below.
All lights
flashing A serious error has occurred. Contact your dealer.
All lights on Waste ink pad in the
printer is saturated. Contact your dealer to replace it.
Lights Cause Solution
Turn off
or
Turn off
If the paper is not ejected, try the procedures below.
3.0 mm
soft, dry cloth
Close the cover
tightly.
1. Nozzle Check
Try 1. Nozzle Check
Bis off
Press for three
seconds
WaitFlashing On
2. Print Head Cleaning
Turn off
Banding
Faint
Hold down the ybutton and
then press the Pbutton.
Hold down both buttons until
the Plight begins to flash,
then release the buttons.
Colors missing
Good printout
Problem with printout
&Run a nozzle check
= Flashing, / = On