Ercol Siena 4530 User manual

4530 Siena Breakfast Table
Thank you for purchasing this Siena breakfast table. Please read the instructions carefully before use to ensure
safe and satisfactory operation of this product.
Pre- assembly preparation
Please ensure instructions are read in full before attempting to assemble this product
This item is HEAVY
Please check the pack contents before attempting to assemble this product. A full checklist of components is
given in this leaflet. If any components are missing, please contact the retailer from whom you purchased this
product.
This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING to avoid personal injury and (or) damage to the product.
This product takes approximately 20 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG
CHILDREN.
Ref: 00237/4530

Fittings and parts checklist
ATop Panel x 1
Connection panel x 1
Allen key x 1
30mm Bolt x 6
Column x 1
Base panel x 1
80mm Bolt x 2
Nut x 2
Locking washer x 2
Flat washer x 2
Spanner x 1
B
C
D
E
F
G
H
I
J
K
A
B
C
D

1. Insert the column(C) into the connection panel (B) as shown below. No fittings required in this step.
Step by step assembly instructions
Using the spanner(E) to fix the 2pcs nut (I), 2pcs locking washer (J) and 2pcs flat washer(K) onto the bolts
as shown below. Tighten the nuts to make sure that the rail (C) and connection panel (B) hold in place well.
.2
Fittings B
C
Fittings
I * 2
J * 2
K * 2
E * 1
E
I * 2
J * 2
K * 2

PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buckinghamshire. HP27 9PX www.ercol.com
3. Assemble the connection panel (B) onto the top panel (A) by using the 6pcs 30mm bolts(G) with the help of
the allen key (F) provided. Steps see below.
Fittings
G * 6
F*1
A
B
C
G * 6
4. The last step assemble the base panel (D) onto the column (C) by using the 2pcs 80mm bolts(H) with the help of
the allen key (F) provided. Steps see below.
Then lift the table onto its base so that the top panel is facing upwards and assembly is complete.
Fittings
H * 2
F*1
If the table is not level on your floor use the wedges provided, and snap them off so that they do not protrude
out from the base panel. you can also snap them lengthways if desired.
D
H * 2