Ercol Bosco 1320 User manual

Bosco
Thank you for purchasing this Bosco bed. Please read the instructions carefully before use to ensure safe
and satisfactory operation of this product.
Pre-assembly preparation
Please ensure instructions are read in full before attempting to assemble this product
Necessary Tools
This item is HEAVY
Please check the pack contents before attempting to assemble this product. A full checklist of components
is given in this leaflet. If any components are missing, please contact the retailer from whom you bought
this product.
This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING to avoid personal injury and (or) damage to the product.
This product takes approximately 30 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG
CHILDREN.
1320 super king bed
Ref: 00329/1320

Fittings and parts checklist
A Headboard x 1 H
Half moon washer
B Footboard x 1
C Side rails x 2 J
Spanner x 1
D Support rail x 3 K
Central brackets x 6
E
Bed slats x 34
L
Washers x 6
F
Ends capfor bed slatsx 68
M
Nuts and bolts x 6 each
G Threads x 8
25mm Screws x 36
x 8
I

1. Push the threads G into the headboard and the footboard as shown below.
Tighten the threads by hand ensuring that there is approximately half of the threads still showing.
Step by step assembly instructions
2. Making sure the holes in the side rails,C, are facing upwards,AND you have the Left and Right rails, (see
page 2) on the corret sides, locate these side rails onto the protruding threads on the headboard and foot
board.As you do this, slide a half moon washer onto the thread when it comes through into the circular
hole in the side of the rail, then screw on one of the 8 nuts FINGER TIGHT ONLY. Repeat with the other 3
corners. then TIGHTEN FIRMLY WHEN ALL FOUR CORNERS ARE SECURED.
Using the M 36 x 25mm screws, attach the two brackets into the headboard and the footboard using the
pre-drilled holes, tighten with a phillips screwdriver.
Making sure the holes in the centre rail are facing upwards, put the centre rail into the two brackets.
Secure it in place using the 6 x 45mm bolts, and the 6 washers and nuts.

3. Push a plastic cap onto each end of a slat and with the peg facing downwards push the slat into the pre
drilled holes as shown below. Repeat for all the slats. Then assemble completed.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buckinghamshire. HP27 9PX www.ercol.com