ETEKCITY EB4074C User manual

1
Digital Body Weight Scale
Model: EB4074C
User Manual
Questions or Concerns?
Mon–Fri, 9:00 am–5:00 pm PST/PDT
[e-mail] • [phone]
1
1
2

2
Thank you for purchasing the
Digital Body Weight Scale by Etekcity.
If you have any questions or concerns, please reach out to our
helpful Customer Support Team at [e-mail].
We hope you enjoy your new scale!

3
Table of Contents
Package Contents
Specications
Safety Information
Function Diagram
Before First Use
Operation
Using the Scale
3
3
4
6
7
7
7
Replacing the Batteries
Cleaning the Scale
Troubleshooting
Warranty Information
Customer Support
8
8
9
10
12
Specications
Package Contents
Weight Capacity 400 lb / 180 kg
Increments 0.2 lb / 0.1 kg
Weight Units lb / kg
Platform Tempered Glass
Dimensions 11.9 x 11.9 x 0.95 in /
30.3 x 30.3 x 2.4 cm
Battery 2 x 1.5V AAA Batteries
Auto-Off 15 seconds
1 x Digital Body Weight Scale
2 x 1.5V AAA Batteries
1 x Quick Start Guide

4
Safety Information
• Check the scale before using. Do not use the scale if it is damaged
in any way.
• Do not strike or bang on the scale and do not use the scale if
there is a slight crack on the glass. Due to the nature of tempered
glass, the glass will shatter if there is a slight crack. If you see a
crack, contact Customer Support (see page 12).
• The glass platform is slippery when wet. Always make sure the
platform and your feet are dry before stepping onto the scale.
• Place the scale on a hard, at surface.
• To weigh safely and accurately, stand with your feet shoulder-
width apart while on the scale. Do not stand on the edge of the
scale or jump on the scale.
Please read and follow all instructions and safety guidelines in
this manual.
READ AND SAVE THESE INSTRUCTIONS
General Use

5
• Avoid standing on the scale for a long period of time.
• Do not overload the scale. Maximum weight capacity is
400 lb / 180 kg.
• Keep the scale in a cool area with low humidity. Keep the scale
away from heat sources, such as ovens or heaters.
• Store the scale horizontally, not vertically.
• For household use only. This scale is not intended for commercial
use.
• Handle with care.
• Do not mix new and old batteries.
• If the scale is not in use for a long period of time, remove the
batteries to extend the lifetime of the scale.
Batteries

6
Function Diagram
A. Display
B. Platform
C. Anti-Skid Padding
D. Unit Conversion Button
E. Battery Compartment
E
1
1
2
3
4
5
D
C
A
B

7
Before First Use
1. Open the battery compartment on the underside of the scale.
Remove the included AAA batteries.
2. Remove the plastic strip.
3. Replace the batteries. Follow the guidelines in the battery
compartment to match the +and –terminals.
Using the Scale
Operation
1. Place the scale on a hard, at surface.
Note: Using the scale on soft surfaces such as carpets and mats will
result in inaccurate measurements.
2. Step on the scale, then step off. Wait for the screen to display
“ ” before using.
3. Stand on the scale until the display ashes several times,
showing your nal measurement.
Note:
• Press the unit conversion button on the underside of the scale to switch
units between pounds (lb) and kilograms (kg).

8
Replacing the Batteries
Cleaning the Scale
1. Open the battery compartment on the underside of the scale.
2. Remove the old batteries and dispose of them properly.
3. Install 2 new 1.5V AAA batteries. Make sure the polarities
match.
4. Close the battery compartment, place the scale on a hard, at
surface, and wait for the display to show “ ” before using.
1. Use a slightly damp cloth to clean the surface of the scale,
followed by a soft, dry cloth to wipe away the remaining
moisture.
2. Do not use chemical or abrasive cleaning agents to clean the
scale.
Clearing the Scale
If the scale has been moved or ipped upside down, it must be
cleared to ensure accurate results.
1. Place the scale on a hard, at surface.
2. Step on the scale until digits appear on the display, then step
off.
3. The scale will show “ ” when cleared.

9
Troubleshooting
Problem Possible Cause Solution
Scale does not turn on.
Plastic strip is still in the
battery compartment.
Open the battery compartment cover
and remove the plastic strip.
Batteries are dead. Replace the batteries. See Replacing
the Batteries (page 8).
Batteries are not properly
installed.
Insert batteries under the correct
polarity as marked on battery
compartment.
Display backlight does not
come on when stepping
on scale.
Scale may be malfunctioning. Contact Customer Support
(see page 12).
Display shows “ ”.
Weight exceeds 400 lb /
180 kg.
Remove weight from the scale. Use
a different scale with a higher weight
range.
Item being weighed is too
light. Use a different scale to measure item.
Display shows “ ”. Battery power is low. Replace the batteries. See Replacing
the Batteries (page 8).
Display shows “ ”. Scale needs to be cleared.
Please place the scale on a at
surface and wait for it to be cleared
before using it.
Reading is inaccurate.
Scale is not on a level
surface. Place scale on a level surface.
Scale was not cleared
properly.
Step off the scale, wait for the display
to show “ ”, and step back on the
scale.
Remove the batteries for 45 seconds
and replace them to reset the scale.
If your problem is not listed, please contact Customer Support (see page 12).

10
Warranty Information
Product Digital Body Weight Scale
Model EB4074C Series
For your own reference, we strongly recommend that you record your order ID and
date of purchase.
Order ID
Date of Purchase
TERMS & POLICY
Etekcity Corporation (“Etekcity”) warrants this product to the original purchaser
to be free from defects in material and workmanship, under normal use and
conditions, for a period of 2 years from the date of original purchase.
Etekcity agrees, at our option during the warranty period, to repair any defect in
material or workmanship or furnish an equal product in exchange without charge,
subject to verication of the defect or malfunction and proof of the date of
purchase.
There is no other express warranty. This warranty does not apply:
• If the product has been modied from its original condition;
• If the product has not been used in accordance with directions and
instructions in the user manual;
• To damages or defects caused by accident, abuse, misuse or improper or
inadequate maintenance;
• To damages or defects caused by service or repair of the product performed
by an unauthorized service provider or by anyone other than Etekcity;
• To damages or defects occurring during commercial use, rental use, or any
use for which the product is not intended;
• To damages or defects exceeding the cost of the product.