EtherWAN EL2242-BT User manual

Copyright 2021 EtherWAN Systems, Inc. Page 1
All Rights Reserved
EL2242-BT
7/15/2021
EL2242-BT Hardened PoE Media Converter
Installation Guide
1 Unpacking
Unpack the items. Your package should include:
➢One EL2242-BT PoE Media Converter
➢Power input terminal block
➢Wall and DIN-Rail mounting hardware
brackets
If items are missing or damaged, notify your
EtherWAN representative. Keep the carton and
packing material.
More information available at:
https://www.etherwan.com/us
For warranty information, visit:
https://www.etherwan.com/us/support/warrant
y-policy
2 Equipment Needed
➢Category 5e or better cable for RJ-45 port
➢SFP Module
➢Single Mode/Multimode Fiber Cable
➢Power supply with supplied voltage within
specified range of 52 to 56VDC
3 Select a Location
➢DIN-rail installations: Attach the bracket on
the unit using the included screws and then
mount on a DIN-rail.
➢Wall installations: Attach the brackets on the
unit using the included screws and then
mount on a wall.
➢Identify a power source within 6 feet (1.8
meters).
➢Choose a dry area with ambient temperature
between -40 and 75ºC (-40 and 167ºF).
➢Keep away from heat sources, sunlight, warm
air exhausts, hot-air vents, and heaters.
➢Make sure there is adequate airflow.
4 Connect to the Ports
The EL2242-BT has the following ports:
➢1 10/100/1000 Mbps copper port
➢1 dedicated 100/1000 SFP slot
10/100/1000BASE-T Port
Port can be connected to a switch, a router or a
PoE device (PD).
SFP Slot
100/1000BASE SFP slot.
5 Connect Power
Terminal Block
Connect the unit to a suitable power supply using
appropriate wire, 18-24AWG, rated for 105°C or
higher.
Redundant power is supported. However, only
one power input is required to operate the unit.
1. Connect power wires to the appropriate
V1+/- or V2+/- pins on the terminal
block.
2. Connect the grounding wire to the ground
screw.
3. Plug the terminal block into the socket.
6 Front Panel LEDs
LED Panel Layout
LED
Color
Status
Power
1&2
Green
ON = power detected
OFF = power not detected
PoE
Amber
ON = PD is detected
Off = No PD detected
RJ-45
Link/Act
Green
ON –TX port is detected
FLASHING –TX data is
transmitting
SFP
Link/Act
Green
ON –FX port is detected
FLASHING –FX data is
transmitting/receiving

Copyright 2021 EtherWAN Systems, Inc. Page 2
All Rights Reserved
EL2242-BT
7/15/2021
EL2242-BT Hardened PoE Media Converter
Installation Guide
7 Dip Switch Settings
DIP Switch Settings
The DIP switches on the EL2242-BT can be used
to enable/disable Link Fault Pass Through (LFPT)
and the speed of the SFP port.
Warning: Make sure power is disconnected
before adjusting the DIP switch
Dip
1
OFF
LFPT disabled
(Default)
ON
LFPT enabled
Dip
2
1000
SFP Speed
1000M (Default)
100
SFP Speed
100M