EtherWAN EL2211 User manual

Gigabit Ethernet Media Converter
V11
This quick start guide describes how to install and use the Gigabit Ethernet media converter. The converter introduced here provides one
channel media conversion solution.
Physical Description
Product Overview
This Gigabit Ethernet media converter is a plug-and-play device. Connect the supplied AC to DC power adaptor to the receptacle on the rear
panel of the Gigabit Ethernet media converter, and then attach the plug into a standard AC outlet.
DIP Switch
No. Down Up
1 Disable LFPT Enable LFPT LFPT: Link-Fault-Pass-Through function
2 Enable Auto-Negotiation for TX port Enable Force mode for TX port
3 TX port Force mode: Full-duplex TX port Force mode: Half-duplex
4 TX port Force mode: 100Mbps TX port Force mode: 10Mbps
5 Function reserved Function reserved
6 Function reserved Function reserved
<Note> Power must be off/on after re-setting LFPT function.
The 10/100/1000Base-TX and 1000Base-SX/LX/BX Connectors
The 10/100/1000Base-TX Connection
The following lists the pinouts of 10/100/1000Base-TX port.
The 1000Base-SX/LX Connection
The fiber port pinouts
The Tx (transmit) port of device I is connected to the Rx
(receive) port of device II, and the Rx (receive) port of
device I to the Tx (transmit) port of device II.
The WDM 1000Base-BX Connection
The fiber port pinouts
Only one optical fiber is required to transmit and receive
data.

Gigabit Ethernet Media Converter
V12
The Port Status LEDs
LEDs State Indication
Steady Power onPWR Off Power off
Steady LFPT function enabledLFPT Off LFPT function disabled
Steady Copper port: A valid network connection established
LNKC stands for LINK/Copper
LNKC
Off No connection
Steady Green: Connection at the speed of 1000Mbps
Amber: Connection at the speed of 100Mbps
Copper Port
10/100/1000
(Mbps) Off Connection at the speed of 10Mbps
Steady Fiber port: A valid network connection established
LNKF stands for LINK/Fiber
LNKF
Off No connection
Steady Full-duplex mode
FDX stands for Full-duplex
FDX
Off Half-duplex mode
Functional Description
•Complies with IEEE802.3 10Base-T, IEEE802.3u 100Base-TX, IEEE802.3ab 1000Base-T, and IEEE802.3z 1000Base-SX/LX.
•Supports IEEE802.3x Flow control: Flow control for Full-duplex and Back pressure for Half-duplex.
•DIP switch configuration for “Link-Fault-Pass-Through”.
•Gigabit transmission supports 9K Bytes jumbo frame.
•1000Mbps-Auto/Full-duplex, 10/100Mbps-Full/Half-duplex, Auto-Negotiation, Auto-MDI/MDIX.
•Full wire-speed forwarding rate.
•Operating voltage and Max. current consumption: 0.23A @ 12VDC. Power consumption: 2.76W Max.
•Power Supply: 12VDC external universal PSU.
•0 to 5℃0 (32℃℉to 122℉) operating temperature range.
•Aluminum case.
•Supports Wall Mounting installation or use with media converter chassis system.