Watch the Video!
© ETON
TS18, 18 litre Drinker Assembly Instrucons
Place the 3 leg posioners into the grooves on the underside of the base
Screw the leg posioners to the base using the screws provided and a
cross head/Phillips screwdriver (not included). 2 screws are needed for
each leg posioner and pressure will need to be applied to pierce the
screws through the plasc in the base.
Aach the 3 leg feet to the 3 legs
Aach the 3 fully assembled legs to the 3 slots of the leg posioners on
the base.
Push part A of the base connectors up through the hole underneath the
base
Flip the base over so that it’s standing on its legs and push the base insert
into posion on the base
Place the plasc insert into posion on the base
Turn the drinker bucket upside down and insert the stopper into the small
hole. Using your nger to keep the stopper in place, turn the bucket up
right and posion it onto the base
Insert the cap into the inside of the bucket to cover the valve hole
Add part B of the base connectors on top of part A on the inside of the
bucket
Screw part C of the base connector on top of part A and B so that the
base and bucket are securly connected.
Aach the handle to the bucket and place the lid on top
1. 2. 3.
4. 5. 6.
7. 8. 9.
10.11. 12.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Call: 01246 264630
Email: sales@etonlivestockappliances.com
www.etonlivestockappliances.com
