Note: For the best possible reception, position your watch near a window in an upright manner, with the dial
facing the window (see figure 2) or outdoors. If the watch fails to set itself, leave it all night long near the
window.
The signal cannot be received for the following reasons:
▪near high buildings.
▪near a built-up area.
▪in an area outside the radio signal coverage area.
▪near electronic or electrical equipment such as TV, wireless radio, mobile phones
computer which may cause undesirable signal interferences.
▪near sources of magnetism or electro-magnetism.
▪near heat sources.
▪in conditions of bad weather.
QUALITY SIGNAL RECEPTION CHECK
In normal time mode display, press button A once.
Refer to the table: “Signal strength state”above in “Manual reception”section.
SETTING OF LCD DISPLAY
The LCD Display can show second, signal status, date and day of week. Press button A stepwise to choose the
desired option.
A : Language of LCD Display
1. Press button B and hold for 3 seconds until the LCD display shows EU.
(Note : If the time zone has been changed, the screen will not show EU, but the new time zone code,
please see "Time zone setting" below.)
2. Press button B Once, the LCD display shows DE (German) or EN (English).
3. Press button A to choose.
4. Press button B to confirm.
5. The day of week is now displayed in the chosen language.
B: Time zone setting
You can adjust the time zone to enable your watch to display the correct time of other countries when you travel.
1. Press button B and hold for 3 seconds until the display shows EU.
2. Press button A stepwise to choose, check with the list of time zone.
3. Press button B to store.
IMPORTANT : If your country is in daylight saving time and the target country does not have daylight saving
time, please adjust the time zone forward by one hour.
WARNING
• DO NOT operate the crown or buttons in the water or when the watch is wet.
• To prolong the appearance of your watch, avoid contact with the following: Perfumes, hairspray, cosmetics,
detergents, adhesives and paints as they cause discoloration, deterioration and damage.