Exposure OLAS CORE User manual

0347
1152
0438
Near
1152
Near
0347
Near
MOB
ID: 0438
1. Connect the OLAS app to the Core. For more
information on how to do this please refer to the Core
Setup Instructions.
Testing the alarm
FOR FIRMWARE VERSION 2.0+
2. Ensure all OLAS transmitters are seen on the OLAS app
homescreen.
3. Switch off the OLAS transmitters.
OLAS tag: press the button for 4 seconds, until a red flash is seen.
OLAS Float-On: press the button for 4 seconds until the bi-colour
turns red.
4. If testing with an OLAS Tag or OLAS Float-ON the
alarm will occur after your set 'Alert Time' which has a
default of 3 seconds. If testing with an OLAS T2 tag the
alarm will occur immediately after it is switched off.
Press and hold the MOB button
on your GPS Chart Plotter
Send a MOB DSC alert
using your VHF
Tom
Overboard!
Step 1
Step 2
Continue to recovery
5. Press the control switch on the Core once. This puts the
system into pause.
Press and hold the MOB button
on your GPS Chart Plotter
Send a MOB DSC alert
using your VHF
Tom
Overboard!
Step 1
Step 2
Continue to recovery
OR
MOB
exposureolas.com
4. If using an OLAS T2 go to 'Alert Settings' in the menu
and select the alert function for the OLAS T2. Now
when you switch off your OLAS T2 tag it will activate
the alarm immediately.
Alert Settings
Sound
Siren (Default)
Volume
Detection Time
(seconds)
7
2
15
Alert Delay
(seconds)
4
2
30
Pause Alert Sound
OLAS T2 Function
Switch Active
(seconds)
5
60
5
0438
Far
MOB
Tutorials
Online
Solo Mode
Vessel
Information
Alert Settings
Device Selection
FAQ ’s
Close OLAS
Firmware Update
0438
Near
MOB

6. Press the control switch again once. 3 beeps will sound
to indicate that the transmitter is still missing, and the
system is still in pause state.
exposureolas.com
8. Place the transmitter next to the Core. 9. Press the control switch once. The Core will beep, the
number of beeps represent the number of tags it is now
tracking. Tracking resumes. Solid red on the control
switch indicates it is tracking correctly.
7. Switch the OLAS transmitter back ON.
Press for 4
seconds until
light green
Double press
Testing the alarm
FOR FIRMWARE VERSION 2.0+