Exsys EX-6072-4K User manual

1
Thank you for purchasing this Dual Channel Gigabit Ethernet PCI Express Card with
4KV Isolation. It is the fastest LAN host adapter available in the market that is
specially designed to connect dual channel 4KV isolated gigabit LAN channels to
any computer with PCIe (PCI Express) slots. It supports crossover detection and
auto-correction feature for the easy network cabling.
Features:
✓Fully PCI Express Base Specifications 1.1 Compliant
✓Supports Dual 4K VAC Gigabit Ethernet Ports over a PCIe Switch
✓Supports Full Duplex Flow Control (IEEE 802.3x)
✓Fully Compliant with IEEE 802.3 IEEE 802.3u, IEEE 802.3ab
✓Supports IEEE 802.1Q VLAN tagging, Crossover Detection & Auto-Correction
✓Microsoft NDIS5, NDIS6 Checksum Offload (IPv4, IPv6, TCP, UDP) and Segmentation
Task-offload (Large send v1 and v2) support
✓Supports Jumbo Frame to 9K bytes
✓Supports Win98SE, ME, 2K, XP, XP64, Vista, Win7, 8.x, 10 and others
EX-6072-4K
Dual Channel Gigabit Ethernet PCIe Card,
w/ 4KV Isolation
1. Introduction
2. Board and Bracket Layout
Short bracket will be
assembled if the low profile
model is shipped
RJ45 Connectors:
CH2 CH1
CH2 CH1
LINK (ACT) LEDs

Dual Channel Gigabit Ethernet PCIe Card, w/ 4KV Isolation
2
Due to the hot-plug feature of the PCI Express, the installation of the PCIe Dual
Channel Gigabit Ethernet card is quite straightforward.
1. Turn the system power OFF before installation!
2. Use static electricity discharge precautions. To avoid damaging any
components on the card, handle it by edges.
3. Remove the chassis cover from your computer
4. Locate an unused PCI Express slot (typically white and smaller) and remove
the corresponding slot cover from computer chassis.
5. Plug the Dual Channel Ethernet PCIe card to the unused PCI Express
expansion slot and attached the I/O card bracket to the computer chassis
screw.
6. Put the chassis cover back on the computer.
7. Turn ON the power of your computer and peripherals.
8. Proceed with Software Driver Installation.
9. Installing LAN cables
Each RJ45 has its corresponding LED indicator. Connect the Cat5 LAN cables
to both RJ45 connectors. The corresponding ‘LINK(ACT)’LED will light if link is
on. The same LED will flash when transferring data. This following table lists
the LEDs’definition:
LED Name
Color
LED Function
LINK(ACT)
Green
Steady on: Linked
Blinking: Transferring Data
3. Installing the Gigabit Ethernet PCIe Card

Dual Channel Gigabit Ethernet PCIe Card, w/ 4KV Isolation
3
The Gigabit Ethernet drivers are shipped in the following folder of the driver CD.
Please browse to the corresponding driver folder when Windows ask you to specify
the driver location. Then follow the on-screen instructions of the Windows to
complete the installation.
You can use Device Manager to check the installation. Here are the screen shots
showed you that it was installed correctly:
4. Windows Driver Installation

Dual Channel Gigabit Ethernet PCIe Card, w/ 4KV Isolation
4
2 Gigabit Ethernet
ports shown here
PCI-to-PCI bridge
devices appeared