Faber PB10 User manual

70 Installation and User manual:
Model
Installation and User’s manual PB - GB
Subject to technical changes
Installation TopFix / RecessFix [R1]
Do not damage the product when using a sharp knife to open
the packaging! Fitting screws: Use a size-2 screwdriver (PO-
ZIDRIVE) or use an electric screwdriver at it’s lowest torque.
Rail removal: Use a at screwdriver of max. 6 mm wide. Only
use the original screws enclosed, to prevent malfunctioning
from using too thick screw heads!
X=5 cm
xxy
xxy
max. 35 cm
max. 35 cm
A
B
B 1 B 2
A
BC
Removal
4 Bediening
B
C
A
1
1
Clip installation (toprail)
2
Clip installation (bottom rail)
3
Installation sequence
4
Tensioning/slackening the steel wire
5
Operation
3-A1 3-A2
3-B1 3-B2
Rail installation sequence on Clips
Note: if necessary, before clicking the rail
into place, slacken the steel wire. After
clicking, place cover on the bottom clips.
Push rmly to the right/left to tension/slacken
the steel wire
3 3 10 - 80 cm
4 4 181 - 115 cm
5 5 1116 - 150 cm
6
8
10
Product width Number of parts
[R1]
21-03-2014
PB10
PB15

71 Installation and User manual:
Model
Installation and User’s manual PB - GB
Subject to technical changes
FaceFix installation to a window frame / wall [F1]
Do not damage the product when using a sharp knife to open
the packaging! Fitting screws: Use a size-2 screwdriver (PO-
ZIDRIVE) or use an electric screwdriver at it’s lowest torque.
Rail removal: Use a at screwdriver of max. 6 mm wide. Only
use the original screws enclosed, to prevent malfunctioning
from using too thick screw heads!
3 3 3 3 1 12 30 - 80 cm
4 4 4 4 1 16 481 - 115 cm
5 5 5 5 1 20 5116 - 150 cm
X=5 cm
xx
xx
max. 35 cm
max. 35 cm
A
B
A
BC
Removal
B
C
A
1
FaceFix installation (top rail)
2
FaceFix installation (bottom rail)
3
Fitting the lower covers
5
Tensioning/slackening the steel wire
4-A1 4-A2
4-B1 4-B2
Rail installation sequence on Clips
6
Operation
4
Installation sequence
Note: if necessary, before clicking the rail
into place, slacken the steel wire. After
clicking, place cover on the bottom clips.
Push rmly to the right/left to tension/slacken
the steel wire
Number of partsProduct width
[F1]
21-03-2014
PB10
PB15