Fanco Infinity DC. All Rights Reserved.
Please observe the following general safety precautions carefully before and during all phases of
handling, installation, removal, operation and maintenance of this product. Failure to comply with these
precautions violates safety standards of design, manufacture and intended use of the product. Fanco
assumes no liability for customer’s failure to comply with these requirements.
SAFETY WARNINGS
1. Read all instructions and safety information. Review assembly diagrams provided before
installing your new ceiling fan.
2. This fan must be installed by a licensed and qualified electrician according to SAA and
local authority regulations.
3. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their
safety.
4. Children should be supervised to ensure that they do not play with the appliance.
5. All electrical works must only be undertaken after disconnection of the power by
removing fuses or turning off the circuit breaker, to ensure all pole isolation of the
electrical supply.
6. Do not use outdoors where it could be exposed to water or moisture.
7. If unusual oscillating movement is observed, immediately stop using the ceiling fan and contact
licensed electrician or Fanco Customer Care.
8. Replacement of parts of the safety suspension system device and mounting of the suspension
system shall be performed by licensed electrician.
9. This manual is not intended to instruct or assist untrained or unqualified persons to install this
ceiling fan.
10.It is the responsibility of qualified, licensed installer and user to apply common sense and
care at all times during installation and operation.
HOW TO CHOOSE A PROPER LOCATION FOR CEILING FAN
1. According to regulations and to provide a safe clearance from the floor, the lowest point on the
fan blade must be at least 2.1 metres (7 feet) from the floor.
2. For fan installed enclosed outdoors, the fan must be installed at least 1.5m from the perimeter
of roof/eaves of the enclosure to protect the product from direct or indirect rain water or
sunlight.
3. The chosen location for the fan must not allow the rotating blades to come into contact with any
object.
4. Please check carefully and make sure that ceiling joists are strong enough and of adequate size
to support the weight of about 35 kg.
5. To reduce the risk of fire, electrical shock or personal injury, please make sure that the fan
hanger bracket is directly supported from the building structure. Do not mount to an outlet box.
