Fanco PWFC750DC Instruction Manual

30” Commercial
DC Wall FanDC Wall Fan
Installation / User Manual

1
Wall fan instruction booklet
Thank you for purchasing your Fanco 30” Commercial DC Wall Fan. Please read all
instructions carefully before assembly and use.
IMPORTANT SAFEGUARDS
Read all instructions carefully, even if you feel you are quite familiar with this type of
appliance. When using electrical appliances, in order to reduce the risk of re, electric shock,
and/or injury, these basic safety precautions should always be followed:
1. Use this fan only as described in this manual. Any other use not recommended by the
manufacturer may cause re, electric shock, or injury to persons and may void the warranty.
Improper installation may result in the risk of re, electric shock, or injury to persons.
2. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, lack of experience and knowledge, unless they
have been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety.
3. Children should be supervised to ensure that they do not play with the appliance.
4. The installation of a residual current device (safety switch) is recommended to provide
additional safety protection when using electrical appliances.
5. Remove the product from packaging and check all components are in good condition
before use. Do not use the fan if you nd a damaged part.
6. Ensure that the fan is switched off from the supply mains before any maintenance,
assembly, or disassembling parts.
7. If unusual oscillating movement is observed, immediately stop using the fan and contact
the manufacturer, its service agent or suitably qualied persons.
8. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualied persons in order to avoid a hazard.
9. This product is for indoor use only. Do not place the fan in or near an open window, rain
and other weather elements may cause an electrical hazard.
10. Do not immerse or expose the product to water, moisture or other liquids.
11. Never insert ngers or any object through the guards.
12. Make sure your hands are dry before operating the electrical appliance.
13. Do not cover the product, or use the product near curtains.
14. Caution! Risk of electric shock: Do not attempt to open any part of the motor housing, as
a risk of electrical shock may exist.
IMPORTANT NOTE:
The important safeguards and instructions given in this manual are not meant to cover
all possible conditions and situations that may occur. It must be understood that common
sense, caution and care are factors which cannot be built into any product.

2
Model Number Rated Voltage Rated DC
Motor Power
Blade
Size Weight Controller
PWFC750DC 220-240 V AC Max. 170W DC
motor
30 inch-
es 10.4 kg
5 Speed digital
controller with
timer
Front cover
Power cable
Fan Bl ade Rear cover
DC Motor Ass embly
Iron plate
Iro
Motor connector
Control box
n pipe
TTIIMMEERR
OONN//OOFFFF

3
INSTALLATION AND ASSEMBLY
SELECTING A LOCATION
1. Choose a location for mounting mounting
plate, where the structure is capable of
carrying a load of at least 60 kg, with
mounting screws or bolts and nuts (not
provided). Customer needs to purchase
mounting screws and bolts depending on
the structure and material of mounting
surface.
2. Insert mounting pipe into the mounting
plate. Align the hole on the pipe with
bottom screw on the mounting plate.
Secure the pipe by tighten 2 screws on the
mounting plate.
4. Loosen the rear cage locking screws from
the motor. Place the rear cage over the
motor shaft. Align screw holes of rear cage
with holes on the motor and secure the rear
cage by screws taken off from the motor.
5. Place the blade onto the motor shaft and
fasten it by tightening the blade locking
screw on the blade.
3. Take off the bolt, washer and nut from the
top of the pipe. Place the motor on the pipe
and x the motor securely on the pipe with
the bolt, nut and washer.
6. Align the top security hook the top center of
the rear cage. Match screw holes of front and
rear cages together. Secure the front and rear
cages together by pressing security locks.
7. Screw cable clamps on the mounting pipe.
IMPORTANT: check if the length of the cable
is sufficient for oscillation before turn on the
fan! Protect the cable from strain!

4
OPERATING INSTRUCTIONS
1. Press the ON/OFF button to switch the fan on or off.
2.Choose a speed setting from 1-5 (1 Slowest & 5 Fastest) by pressing the “+” or “-” buttons.
3.Press TIMER button to start or cancel countdown timer. Adjust desired hours (between 1 to
8 hours) for timer setting by pressing the “+” or “-” buttons when timer display is on.
4. Adjust screw on the bottom of the motor to choose either fixed (forward facing) or
oscillation.
Position 1: Fixed - forward facing
Position 2: Oscillation (Note: side screw must be tightened for oscillation)
MAINTENANCE INSTRUCTIONS
1. Periodic cleaning of your fan is the only maintenance required (approximately every 6 months).
2. WARNING! Ensure that the fan is switched off from the power source before removing the
guard.
3. Remove the guards and the blade, and be careful to not drop the blade!
4. Use a soft cloth with mild soap to clean off any dust or stains, then wipe with a dry cloth.
5. Never use polish or corrosive liquids as this will damage the paint, metal or plastic!
6. Put the blade back and lock the guard securely before use.
7. Reconnect the power cord.
12
Air Volume / Timer
Up
OFF/ON
TTIIMMEERR
OONN//OOFFFF
Air Volume / Timer
down
Swing Light
Note:
Display goes into sleep mode after 3 seconds if no control. To wake up display and see
current status of the fan, simply press any button.
Fan memories last operating setting of the fan before power is cut off, including speeds, on/
off.
Power /Timer
Display
SpeedDisplay
Working Status
Indicator
Timer

5
WARRANTY
The benets conferred by this express Fanco warranty are optional and are in addition to all
relevant implied warranties, rights and remedies available under Australian Consumer Law.
If you encounter issues with the fan during installation, Fanco highly recommends to contact
Fanco for trouble shooting assistance if the installation is during business hours on 03 8658
9588 or to [e-mail].
Warranty details:
Manufacturer’s warranty covers a full replacement for the defect product only.
It does not cover defects within the fan installation or improper maintenance.
Warranty Period:
The warranty period for this product is 12 months.
The warranty period begins from the date of purchase, as determined by the tax invoice
provided by the authorised retailer.
Warranty Limitations and Conditions:
Proof of Purchase – Proof of purchase from an authorised retailer specifying the fan model
and purchase date (such as a tax invoice) must by supplied for the warranty claim to be
processed.
Outdoor use – This product is not intended or recommended for, and is therefore not
warranted for use outdoors including covered and/or enclosed al fresco areas. The warranty
does not cover rust or damage caused by rust to the motor and fan components.
Reasonable wear and tear – is not covered by warranty. The client should ensure the fan
is regularly cleaned and any screws and blade nuts that become loose through normal
operation are tightened. This is not covered by warranty.
Domestic/Personal Use only - This product is not designed or intended for industrial or
commercial use and therefore the warranty will not cover such use.
Purchase from Authorised Retailer – In order for the warranty to apply, the Fanco fan must
have been purchased in Australia from an authorised retailer (please see the Fanco website
for a list of authorised retailers).
Fanco Warranty Applies in Australia Only – Fanco warranty is only available for products
installed and being used in Australia.
Incorrect Installation/Misuse/damage of product – is not covered by warranty. The Fanco
fan must be installed and used according to the installation manual and user guidelines.
Damage caused by external factors such as (but not limited to) power supply faults/surges,
water damage, lighting and other Acts of God is not covered by this warranty. Fanco fans
must only be installed and used with compatible accessories as specied by Fanco. Use with
or wiring with non-authorised accessories and/or other items will void this warranty. If a
Fanco Service Agent determines a problem with the product is due to incorrect installation
or misuse of the product, the product will not be replaced. Fanco does not accept liability for
any direct or consequential damage, loss or other expense arising from misuse or incorrect
installation and operation of the appliance.

6
Warranty Claims
You can claim the warranty at the place you purchased fan or to Fanco directly.
Replace product at place of purchase.
Bring the defect products and proof of purchase to the place of purchase.
Contact Fanco directly
Please submit any warranty claims in writing by one of the following methods;
1. Email to: [e-mail] and attaching the required documents
2. Filling out the warranty claim form on the Fanco website and attaching the required
documents
Please ensure all warranty claims are in accordance with the warranty conditions and
limitations outlined above and that you include proof of purchase
Please allow up to four days from receipt of your warranty claim for a response.
Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and compensation for
any other reasonably foreseeable loss of damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the failure does not
amount to a major failure.
Fanco
18 Cleeland Road
Oakleigh South, VIC 3167
https://www.fanco.com.au/
Tel: [phone]
Email: [e-mail]