Fenix UC52 User manual

Fenix UC52 Flashlight
Technical Parameters
ANSI/PLATO FL1
General Mode Flash Mode
Turbo High Med Low Eco trobe O
Output
3100
Lumens
1000
Lumens
350
Lumens
100
Lumens
15
Lumens
1000
Lumens
100
Lumens
Runtime
42 min 2h 45min 8h 15min 27h
30min
82h
30min / /
Distance
253m 145m 85m 44m 18m / /
Intensity
16,000cd 5,200cd 1,800cd 490cd 80cd / /
Impact
Resistance
1m
Waterproof
IP68, unde wate 2m
Notice: The abovementioned pa amete s (lab-tested by Fenix using the built-in 7.2V/3500mAh Li-ion batte y pack, depending
on the o iginal output of each mode) may va y between envi onments and flashlights.
The flashlight is configu ed to downshift b ightness as batte y level dec eases. Refe to the untime g aph to check actual
untime.
C ee XHP70 LED with lifespan of 50,000 hou s
Built-in 7.2V/3500mAh Li-ion batte y pack
153.5mm Length x 42mm Head diamete x 26mm Body thickness
276 g ams (including batte y)
OLED sc een digitally displays cu ent output level, batte y status and emaining untime
Mic o USB cha ging, inne wate p oofing t eatment

Instant st obe
Lockout function avoids accidental activation
Digitally egulated output maintains constant b ightness
Intelligent ove heat p otection, to p otect f om high su face tempe atu e
Made of aluminum alloy, fitted with stainless steel bezel ing
Toughened ult a-clea glass lens with an anti- eflective coating
Operating Instruction
witches
Maste ①: cont ols Gene al mode and output selection
Auxilia y②: cont ols Flash mode and output selection
ON/OFF
ON: With the light switched off, p ess and hold the Maste switch fo 0.5 seconds to ente Gene al
mode, p ess and hold the Auxilia y switch fo 0.5 seconds to ente Flash mode on st obe.
OFF: With the light switched on, p ess and hold eithe switch fo 0.5 seconds to tu n off the light.
Mode switching
In Gene al mode, single click the Auxilia y switch to ente Flash mode.
In Flash mode, single click the Maste switch to ente Gene al mode.
Output election
In Gene al mode, single click the Maste switch to cycle th ough Eco→Low→Med→High→Tu bo.
In Flash mode, single click the Auxilia y switch to cycle th ough St obe→SOS.
Note: When the batte y level gets ext emely low (about 4%), the light can only be lit up on Eco.
The Flash mode will be locked and i esponsive to any ope ation.
Instant trobe
With the light unlocked and switched off, p ess and hold the Auxilia y switch fo 0.5 seconds, o
single click the Auxilia y switch on Gene al mode, the light can ente instant st obe.
Lockout Function
Lock: With the light unlocked, simultaneously p ess the two switches fo 3 seconds, the light will
blink at Low twice to indicate locked status.
Unlock: With the light is locked, simultaneously p ess the two switches fo 3 seconds, the light
will be unlocked and activated on last used b ightness.
In locked status, clicking o p essing the switches will activate 2 one-second blinks at Low to
indicate locked status.
Battery Level Indication③
With the light switched off, single click the Auxilia y switch, the OLED sc een will display the

batte y status pe centage, and then goes out in 5 seconds.
Charging④
Plug the USB side of the cha ging cable into the any USB powe supply, uncove the anti-dust cap
of the light. And plug the Mic o USB side of the cha ging cable into the cha ging po t of the light.
When cha ging the OLED sc een will display , and cu ent batte y level will be displayed.
When the light is fully cha ged, the OLED sc een will display . 5V/2A adapto is
ecommended and the no mal cha ging time is about 4 hou s.
Note: 1. Once cha ging is completed, be su e to emove the cha ging cable and eplace the anti-
dust cap to p otect f om dust and fo eign objects.
2. Recha ge a sto ed light eve y fou months to maintain optimum pe fo mance of the batte y.
Intelligent Memory Circuit
The light memo izes the last selected b ightness level on Gene al mode. When tu ned on again
the p eviously used b ightness level will be ecalled.
Overheat Protection
The light will accumulate a lot of heat when it is wo king at Tu bo mode. When the light is
ove heated up to 65 o above, the output will be automatically downshifted to half of tu bo℃
to educe the tempe atu e, and the sc een will display Level 5 -.
Usage and Maintenance
Disassembling the sealed head can cause damage to the light and will void the wa anty.◎
The flashlight may◎ flicke , shine inte mittently o even fail to illuminate fo the following
eason:
A: Poo batte y level.
Solution: Cha ge the light in time
If the above methods don't wo k, please contact you autho ized dist ibuto .
Included
UC52 flashlight, Mic o USB cha ging cable, holste , lanya d, use manual, wa anty ca d
Warning
This flashlight is a high-intensity lighting device capable of causing eye damage to the use o othe s. Avoid shining the flashlight
di ectly into anyone’s eyes.