Fillauer ProCover User manual

Intended Use
The Fillauer ProCover is made of durable and resilient polyurethane
foam that enhances performance and protects the foot module. The
split design makes the cover easy to install and remove for ease of
maintenance andcleaning. The ProCover is intended for use with
the AllPro, AllProPM, or Wave Comfort3.
Performance Characteristics
SkiTrek
Compatible feet AllPro, AllProPM, AllPro XTS,
WaveComfort3
Sizes 22 – 30cm
Weight (26cm) 9.1 oz. (259g)
Material Polyurethane foam
Activity level K3 – K4
Storage and Handling
It is recommended that the ProCover is stored in a cool, clean,
dry environment away from harsh chemicals (chlorine, acids,
acetone,etc.).
Warranty
The ProCover is warrantied for 6 months from date of installation.
Warranty is voided by alteration, misuse of product, or failure to comply
with instructions.
Included Components
Connector Pin × 8
ProCover Right × 1
ProCover Left × 1
Velcro × 4
Replacement Components
Size Component Replacement Kit
Includes 4 Connector Pins and 2Velcro®Straps
22 – 25 182-10-2300
26 – 30 182-10-2350
Warnings and Precautions
CAUTION: The foot shell is waterproof to 1 meter.
However, if it is submerged, the foot and ProCover
should be rinsed with fresh water and dried immediately
to remove salt, chlorine, or debris.
CAUTION: The foot shell is designed to provide
maximum performance of the foot. The life of the foot
shell will depend on level of activity and degree to which
it is protected from wear and damage with socks and
shoes. Socks and shoes should be worn at all times and
should be allowed to dry fully after exposure to water to
prevent damage to the shell.
CAUTION: Patients should inspect the foot shell daily
for signs of cracks or holes and for the presence of sand
or other debris. If the foot shell shows signs of failure,
it should be replaced as soon as possible to prevent
damage to the carbon ber and soling materials. If
debris is present, the foot and shell should be rinsed
and allowed too fully dry.
CAUTION: The foot shell may also be cleaned with a
soft cloth and a soap and water solution or with rubbing
alcohol (70%). Do not use acetone. It will damage the
foot shell.
Qualied Provider
Attachment, adjustment, alignment, and delivery of this device
must be performed by or under the direct supervision of a qualied
prosthetist. Unless stated in this manual, any such activities should
not be attempted by the user and will potentially void the device
warranty.
ProCover
Product Manual

Specications and Preparations
BeforeUse (Risk Management for
Installation andCalibration)
Attention: Deviating from the installation instructions or modifying
the ProCover in any way will void any product warranty and could
lead to product failure and injury to thepatient.
ProCover Installation
1. Insert the foot into one side of the ProCover and press down
rmly so the foot is fully seated in the internalcavity.
2. Install the other side by aligning the four connector pins and
pressing rmly in to place. It is normal to have a slight gap
between the two halves but this can be minimized by rmly
squeezing the two sides together.
3. Install the two Velcro® straps by tightly wrapping them around
the toe and heel channels with the soft sides of the straps
facing out.
4. The cover can be easily removed to aid cleaning the foot and
keep the foot in good working order.
Compatibility
The ProCover is appropriate for use with the adult AllPro DM, AllPro
PM, AllPro XTS, Wave Comfort prosthetic feet. A Fillauer spectra sock
should be used with this device. The t of other manufacturers feet
cannot be guaranteed.
Disposal/ Waste Handling
The product must be disposed of in accordance with applicable local
laws and regulations. If the product has been exposed to bacteria or
other infectious agents, it must be disposed of in accordance with
applicable laws and regulations for the handling of contaminated
material.
www.llauer.com
Fillauer
2710 Amnicola Highway
Chattanooga, TN 37406
423.624.0946
Fillauer Europe
Kung Hans väg 2
192 68 Sollentuna, Sweden
[phone]
EC REP
© 2023 Fillauer LLC
PM350/10-29-18/08-01-23/Rev.1