First Light SCL Series Configuration guide

INSTALL INSTRUCTIONS
SCL SERIES - SOLAR LED AREA LIGHT
First Light Technologies
Document 70-0017 11 March 2019
©Copyright First Light Technologies
www.firstlighttechnologies.com
[e-mail]
Toll Free 1.844.279.8754
PRIOR TO INSTALL
Ensure install location has a minimum of 2 to 3 hours of
direct midday sun exposure for best performance. Install
footing and pole as per specifications. Please handle fixture
with care as scratches will affect appearance and powder
coat durability.
TOOLS REQUIRED
•1/8 inch hex key
•5/32 inch hex key with torque wrench
TO INSTALL
1.
UNPACK MOUNTING ARM. Remove
mounting arm from box and remove
packing material.
2.
REMOVE MOUNTING BOLTS FROM
MOUNTING ARM.Remove mounting
bolts using 5/32” hex key.
3. DRILL HOLES IN POLE.If pole is not pre-
drilled, drill holes in pole as shown. Note:
The .50 inch hole is for a ground wire and is
optional.
4. ATTACH MOUNT TO POLE.Insert backing
plate into pole and thread bolts fully into
backing plate through the mounting arm.
Ensure flat side is placed against the inner
surface of the pole. Torque bolts to 70 in-
lbs.
Backing
Plate
Mounting
Arm
Mounting
Arm
Mounting
Bolts
Pole
Pole
Backing
Plate
Mounting
Arm
Mounting
Bolts

INSTALL INSTRUCTIONS
SCL SERIES - SOLAR LED AREA LIGHT
First Light Technologies
Document 70-0017 11 March 2019
©Copyright First Light Technologies
www.firstlighttechnologies.com
[e-mail]
Toll Free 1.844.279.8754
5. INSTALL LIGHT ON MOUNTING ARM.
Remove light from box and install on the
mounting arm. Tighten chassis bolts with
5/32” hex to 70 in-lb.
6. OPEN LID. Loosen lid fastener with
1/8” hex key and open lid.
7. REMOVE PACKAGING AND CONNECT BATTERY CABLES. Remove packaging material from
interior of light and connect the battery cables, ensuring to latch the connectors.
8. CONFIRM LIGHT TURNS ON FOR APPROXIMATELY 20 SECONDS. After being properly
connected, there will be a brief pause and then the light will turn on for 20-30 seconds. The light
will then begin normal operation. If this does not happen, please call us at 1-844-279-8754 for
assistance.
9. CLOSE LID. Close lid and tighten fastener.
10. INSTALL COMPLETE.
Latch Battery Cables
Battery Cables
Battery
Lid
Lid Fastener
Chassis
Bolts
Mounting
Arm
SCL Light