Knightsbridge SPIKEGUBK Instruction Manual

INSTALLATION & MAINTENANCE MANUAL
SPIKEGUBK

These instructions should be read carefully and retained after installation by the
end user for future reference and maintenance.
These instructions should be used to aid installation of the following product:
SPIKEGUBK
GENERAL INSTRUCTIONS
SAFETY
• This product must be installed in accordance with the latest edition of the IEE Wiring
Regulations (BS7671) and current Building Regulations. If in any doubt, consult a qualified
electrician
• Please isolate mains prior to installation or maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed
the rating of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress Protection) rating of this luminaire when deciding the location
for installation
• This product is Class I and must be earthed
• This product is IP65 rated

INSTALLATION
• Provide power to the required point of installation (refer to BS7671 for correct cabling
methods). Suitable IP rated junction boxes should be used where required
• The power source connections should be local and accessible via a suitable IP rated
enclosure
• Choose a position for the luminaire ensuring that the ground is suitable to firmly hold the
spike and luminaire in position. Check that the ground is not liable to flooding and the
spike does not infringe with any underground pipes or cables (see Fig. 1)
•
•
•
•
•
•
•
•
•
•
•
Fig.1

• The body of the product should not rest directly on the ground
• The pre-installed cable supplied is for above-ground use only. Cables that are to be
routed within walls or below ground must be protected by means of suitable conduit or
trunking, (see Fig. 2)
For wall mounting, using the bracket as a template, mark the location for, and drill the fixing
holes ensuring not to infringe with any gas / water pipes or electrical cables (see Fig. 3)
• Connect the luminaire to the mains supply ensuring
correct polarity is observed: Live (Brown), Earth (Green/
Yellow), Neutral (Blue)
• Unscrew the bezel by turning anti-clockwise
• Insert a suitable GU10 lamp (max. 35W) into the lamp
holder. Align the pins and turn 45° clockwise to secure
the lamp (a suction cup is provided to aid insertion /
removal of the lamp where required)
• Replace the bezel ensuring the gasket is not damaged,
and tightened to form a weatherproof seal
• Switch on and check for correct operation
Fig.2
Fig.3
•
•
•
•
•
•
•
•
•

GENERAL
WARNING
This product should be recycled in the correct manner when it reaches the end of its life.
Check local authorities for where facilities exist.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which
may damage the product.
Do not use any source of high-pressure washers to maintain or clean this luminaire.
This product is dimmable dependent on lamp type.
This product is not suitable for installation in or near a coastal or marine environment.
WARRANTY
This product has a warranty of 2 years from the date of purchase. Failure to install this
product in accordance with the current edition of the IEE Wiring Regulations (BS7671),
improper use, or removal of the batch code will invalidate the warranty. If this product
should fail within its warranty period, it should be returned to the place of purchase for a
free of charge replacement. ML Accessories does not accept responsibility for any installation
costs associated with the replacement product. Your statutory rights are not affected. ML
Accessories reserve the right to alter product specification without prior notice.

AVJUN21_V2
130