Fisher & Paykel CG305DNGX1 Guide

Using your Cooktop
1. Identify the dial of the burner you want to use.
2. Press down (a) then turn counter-clockwise to HI
(b).
• The ignitors will start clicking as they spark.
• If there is no clicking, there is no spark to light
the burner. If the burner fails to light turn the dial
back to OFF and see ‘Troubleshooting’.
https://producthelp.fisherpaykel.com/us/Cook/Cooktops/Gas/Steel/Five_Burners/CG305DNGX1/User_Guide_CG305DNGX1/…
Updated: Thu, 11 Nov 2021 20:20:42 GMT
Powered by
1

3. After the burner has lit, adjust the flame anywhere
between HI and LO.
• Do not adjust or leave the dial between HI and
OFF.
4. When you have finished cooking, turn the dial
clockwise back to OFF.
• Check that the burner has gone out.
• Before leaving the kitchen, check that all burners
have been turned off.
https://producthelp.fisherpaykel.com/us/Cook/Cooktops/Gas/Steel/Five_Burners/CG305DNGX1/User_Guide_CG305DNGX1/…
Updated: Thu, 11 Nov 2021 20:20:42 GMT
Powered by
2

Adjusting the Flame on the Dual Work Burner
1. Always start out on HI. Both rings of flame will be on in the
shaded setting range.
When turned all the way down, the
outer ring may appear to flicker. If this
occurs, adjust the dial slightly back
towards HI for a stable outer ring.
2. To use the inner ring of flames only, continue turning the dial
towards LO. Only the inner ring will be on in the shaded setting
range.
https://producthelp.fisherpaykel.com/us/Cook/Cooktops/Gas/Steel/Five_Burners/CG305DNGX1/User_Guide_CG305DNGX1/…
Updated: Thu, 11 Nov 2021 20:20:42 GMT
Powered by
3

Turn the burner OFF and see ‘Troubleshooting’ for what to do next if you experience any of
the following:
• There’s a strong gas smell.
• The flame has been blown out by a draft or extinguished by a spill and does not re-ignite.
• There is no clicking/sparking or there is clicking/sparking, but a burner or burners won’t light.
• The flames don’t burn all the way around a burner, or some flames flicker.
• The flame is yellow or yellow-tipped rather than blue.
• The flames are too large, small, irregular, noisy or lift away from the burner.
Wok Cooking
Use your wok only on the dual wok burner and with the supplied wok stand in place, as shown.
• Make sure that the wok stand is stable: its notches need to fit tightly over the pan supports, as
shown.
• Make sure the wok does not push any other pans aside. This could make them unstable, or
deflect heat onto nearby walls or the countertop.
CG365D Dual Wok Burner illustrated
https://producthelp.fisherpaykel.com/us/Cook/Cooktops/Gas/Steel/Five_Burners/CG305DNGX1/User_Guide_CG305DNGX1/…
Updated: Thu, 11 Nov 2021 20:20:42 GMT
Powered by
4

Small Pan Support
Use the supplied small pan support to keep small diameter pans stable.
https://producthelp.fisherpaykel.com/us/Cook/Cooktops/Gas/Steel/Five_Burners/CG305DNGX1/User_Guide_CG305DNGX1/…
Updated: Thu, 11 Nov 2021 20:20:42 GMT
Powered by
5