Fisher-Price DOODLE PRO M1353 User manual

M1353
™
www.fisher-price.com

1.5V x 2
LR6 ("AA")
For best performance, we recommend replacing the
batteries that came with this toy with two, new LR6 ("AA")
alkaline batteries.
• Locate the battery compartment on the back of the toy.
• Loosen the screw in the battery compartment door with a
Phillips screwdriver. Remove the battery compartment door.
Remove the exhausted batteries and throw them away.
• Insert two new LR6 ("AA") alkaline batteries.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities.
Battery Safety Information
Battery Replacement
Before First-Time Use
IMPORTANT! Before first-time use, completely darken the
drawing screen with the magnetic pencil. Slide the eraser
slowly from side to side to clear the drawing screen. Repeat
this procedure several times to enable the drawing screen to
create the clearest, darkest images.
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of this
product safely. Do not dispose of batteries
in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
•
Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only
to be charged under adult supervision.
2
Consumer Information
• Please keep this instruction sheet for future reference, as it
contains important information.
• Requires two "AA" batteries (included).
• Adult assembly is required for battery replacement.
• Tool required for battery replacement: Phillips screwdriver
(not included).
• Wipe with a clean cloth dampened with a mild soap and
water solution. Do not immerse.
• This toy has no consumer serviceable parts. Do not take this
toy apart.
• Keep water, sand and dirt off this toy.

• Slide the power/volume switch to on with low volume or on with high volume .
• Insert a learning card into the slot on the right side of the toy.
• For number cards, press a number to hear it identified.
• For letter cards, press a letter to hear it identified and learn a word that begins with
that letter.
• Use the magnetic pen to create your own drawings, play games or write messages.
• Slide the eraser from side-to-side to erase the screen.
• When you are finished with the toy, slide the power/volume switch to off .
• Store the cards in the compartment on the back of the toy. Store the pen in the slot
near the top of the toy.
• When sounds from this toy become faint or stop, it’s time for an adult to change
the batteries!
Learning and Drawing Fun!
Power/Volume Switch
Pen Stores Here
3
Eraser

United States Only
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the
user's authority to operate the equipment.
FCC Statement
IMPORTANT! To avoid damage to the drawing screen:
• Use only the magnetic pencil included.
• Do not use regular pencils, pens, crayons, or markers.
• Keep this toy away from extreme heat sources such as
ovens, heaters, radiators and hot vehicles.
• Do not apply heavy pressure or force to the drawing
screen. Heavy pressure is not necessary and could
damage the drawing screen. A light touch makes
a dark line.
Important!
• Use only the special, magnetic pencil included. Do not
use any other object on the drawing screen.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A PRINTED IN CHINA
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. M1353pr-0920