Fisher-Price EZ Play Railway DFJ60 User manual

CONSUMER
CONSUMER
INFORMATION
INFORMATION
BATTERY
BATTERY
INSTALLATION
INSTALLATION
FCC STATEMENT
FCC STATEMENT
Keep this instruction
sheet for future reference,
as it contains important
information.
Adult assembly is required.
Requires two AAA (LR03) batteries
for engine operation (not included).
Tool required for battery installation:
Phillips screwdriver (not included).
1,5V x 2
AAA (LR03)
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
• Loosen the screw in the bottom of the vehicle to
access the battery compartment.
• Insert two AAA (LR03) alkaline batteries.
• Replace the top of the vehicle and tighten the screw.
• If this toy begins to operate erratically, you may
need to reset the electronics. Remove batteries
and reinstall.
• When motion slows or stops, or light dims or turns
off, it’s time for an adult to change the batteries.
• Protect the environment by not disposing
of this product with household waste
(2012/19/EU). Check your local authority
for recycling advice and facilities.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids
that can cause a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they
are only to be charged under adult supervision.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2)
this device must accept any interference, including
interference that may cause undesired operation of
the device.
L’utilisation de ce dispositif est autorisée seulement
aux conditions suivantes : (1) il ne doit pas produire de
brouillage et (2) il doit pouvoir tolérer tout brouillage
radioélectrique reçu, même si ce brouillage est
susceptible de compromettre son fonctionnement.
UNITED STATES ONLY
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation.This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.However, there is no guarantee that
interference will not occur in a particular installation.If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Periodically wipe this toy
with a clean, damp cloth.
Do not immerse the engine.
DFJ60
DFJ60
©2015 Mattel. All Rights Reserved. DFJ60-0970
PRINTED IN CHINA 1100634441-DOM
1,5
V x
2
AAA
(
LR03
)
1,5V x 2
AAA (LR03)
1,5V x 2
AAA (LR03)

PARTS
PARTS
Press to assemble track!
Tip: Press the button on the engine
to start. The engine turns off after
5 minutes. Press the button again
to to restart.
x4
x4
(2 pieces - adult
assembly required)
x2
x2
x5
x5
TRACK LAYOUT
TRACK LAYOUT
ONE-TIME
ONE-TIME
ASSEMBLY
ASSEMBLY