Fisher-Price W9638 User manual

W9638
fisher-price.com
• Please keep this instruction sheet for future
reference, as it contains important information.
• Requires two “AA” batteries (included)
for operation. Batteries included are for
demonstration purposes only.
• Adult assembly is required for battery
replacement. Required tool: Phillips
screwdriver (not included).
• Wipe the toy with a clean, damp cloth. Do
not immerse. This toy has no consumer
serviceable parts. Do not take apart.
For best performance, we recommend
replacing the batteries that came with this toy
with two, new “AA” (LR6) alkaline batteries.
• Locate the battery compartment door. Loosen
the screw in the battery compartment door
with a Phillips screwdriver. Remove the
batteries and properly dispose of them.
• Insert two “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries
for longer battery life.
• Replace the battery compartment door and
tighten the screw. Do not over-tighten.
• When sounds or lights from this product
become faint or stop, it’s time for an adult to
change the batteries.
• If this product begins to operate erratically, you
may need to reset the electronics. Slide the
power switch off and back on.
1,5V x 2
“AA” (LR6)
• Slide the switch ON or OFF .
• This toy will turn off after about one minute of
inactivity. Press any button to restart!
• Start by inserting one of the end posts on the
rail into end slot in the base.
• Press near the bottom of the post to “snap”
in place.
• Repeat this procedure to “snap” the remaining
posts in place.
Hint: The rail is designed to break-away from the base.
Simply reassemble it using the assembly procedure.
• A plastic tab was attached to the toy for
in-store demonstration purposes. While the
tab may have already been removed, check
the bottom of the toy to be sure. If a plastic
tab is still attached, pull and remove the tab.
Throw the plastic tab away.

This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures: Reorient or relocate the receiving
antenna. Increase the separation between the
equipment and receiver. Consult the dealer or
an experienced radio/TV technician for help.
Changes or modifications not
expressly approved
by the manufacturer
responsible for compliance
could void the user’s authority to operate the
equipment. This device complies with Part 15
of the FCC Rules. Operation
is subject to the
following two
conditions: (1) this device may not
cause harmful interference and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
Battery Safety Information
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are used,
they are only to be charged under
adult supervision.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes: (1) il ne doit
pas produire de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout brouillage
radioélectrique reçu, même si ce brouillage est
susceptible de compromettre le fonctionnement
du dispositif.
This Class B digital apparatus complies with
Canadian ICES-003. Operation is subject to the
following two conditions: (1) this device may not
cause harmful interference and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.
PRINTED IN CHINA W9638pr-0921©2012 Mattel. All Rights Reserved.
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.