Fisher-Price L5066 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” batteries (included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver (not included).
L5066
www.fisher-price.com

Parts
#6 x 1/2" Screws – 13
Shown Actual Size
Note: Tighten and loosen all screws with a
Phillips screwdriver. Do not over-tighten screws.
Base
Soft Ball
Foot
4 Plastic Balls
Bear
2 Supports
Paddle
4 Links
2 Hanging Toys
2 Chutes
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. L5066pr-0920

Chutes
This product contains small parts.
For assembly by an adult. Take extra care
during unpacking and assembly.
CAUTION
Assembly
Base
• Position the base upside-down on a flat surface.
• Fit the two chutes into the openings in the base, as shown.
• Insert two screws into each chute and tighten.
1
• Fit the two supports into the openings in the base, as shown.
• Insert two screws into each support and tighten.
2
• Fit the foot onto the two supports.
• Insert four screws into the foot and tighten.
• Set the assembly upright.
• Press and hold the two buttons on the hubs. Then lift the
arch until it “clicks” in place.
3
4
3
Supports Press
Foot
Press

• Press and “snap” the bear onto the post on the arch,
as shown.
Hint: This may require some force.
Bear
5
Assembly
4
• Insert a screw into the back of the bear and tighten to secure
it to the post.
6
• “Snap” the paddle to the post behind the bear.
7
• Connect one link to each hanging toy.
• Connect two links together and attach them to the loop on
the soft ball.
8
Paddle
Hanging Toy
Hanging Toy
Links
Soft Ball
Links
Post Post

Before Use
Please keep small parts such as plastic
tabs out of children’s reach. Throw the
plastic tab away.
CAUTION
Note: A plastic tab was attached to the toy for in-store
demonstration purposes. While the tab may have already
been removed, check back of the bear to be sure. If the plastic
tab is still attached, pull and remove the tab from the toy.
Throw the plastic tab away.
• Attach the soft ball and links to the paddle.
9
• Attach the hanging toys to the bear’s “paws.”
• Or, remove the links and fit the hanging toys into the slots in
the chutes, as shown.
• The gym is now set up for “Overhead Gym” mode.
10
5
Assembly

Battery Safety Information
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of batteries
safely. Do not dispose of the product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only
to be charged under adult supervision.
1.5V x 3
“AA” (LR6)
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities.
For best performance, we recommend that you replace the
batteries that came with this toy, with three, new “AA” (LR6)
alkaline batteries.
• Locate the battery compartment on the back of the bear.
• Loosen the screws in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screws.
• When lights or sounds become faint or stop, it’s time for an
adult to change the batteries!
Battery Replacement
6

Overhead Gym to
Sit-Up Activity Center
• First, remove the soft ball from the paddle, then press and
hold the two buttons on the hubs. Lower the arch down until
it “clicks” into position.
Sit-Up Activity Center
to Overhead Gym
• Press and hold the two buttons on the hubs, then lower the
arch down until it “clicks” into position.
• Attach the soft ball to the paddle.
Press
Press
Press
Press
7

Wipe with a clean cloth dampened with a mild soap and water
solution. Do not immerse.
United States Only
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the
user's authority to operate the equipment.
• Slide the power/volume switch on the back of the bear to on
with low volume ; on with high volume or off .
• Slide the mode switch on the back of the bear to either short
play music or long play music .
• When baby kicks the soft ball on the paddle, the bear’s head
bobs and fun music plays.
• Press the bear’s nose for more fun music and lights.
Flashing Lights and Lively Music! Care
FCC Statement
To prevent entanglement injury, never place
the gym in a crib or playpen. Never add strings,
ties or other products to the gym.
WARNING
8