Fisher-Price N2170 User manual

N2170
www.fisher-price.com
N2171
Each sold separately and subject to availability.
Please keep these instructions for future reference,
as they contain important information.
Requires two “AA” batteries (included) for operation.
Adult assembly is required for battery replacement.
Tool required for battery replacement:
Phillips screwdriver (not included).

In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries
or batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Battery
Replacement
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
Battery Safety
Information
For best performance, we recommend
replacing the batteries that came with
this toy with two, new alkaline
“AA” (LR6) batteries.
• Locate the battery compartment on the
back of the toy.
• Loosen the screws in the battery compart-
ment door. Remove the battery compart-
ment door.
• Remove the exhausted batteries and throw
them away.
• Insert two "AA" (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries
for longer battery life.
• Replace the battery compartment door and
tighten the screws.
• If the toy begins to operate erratically, you
may need to reset the electronics. Slide the
power switch off and then back on.
• When sounds from this toy become faint
or stop, it’s time for an adult to change
the batteries.
1.5V x 2
"AA" (LR6)

Gate
Gate
Rolling, Roaring Fun!
• Slide the power switch on the back of the toy on .
• Lower the gate and push the lever to let the animals out and listen to animal and other
fun sounds.
• Attach the bird to the side of the habitat wall.
• When finished playing, slide the power switch on the back of the toy off .
Push
Push
Push
Push
Gate
Gate

Care
• Wipe this toy with a clean cloth dampened
with a mild soap and water solution.
Do not immerse this toy.
• This toy has no consumer serviceable
parts. Do not take this toy apart.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. N2170pr-0920
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
Consumer Information
United States Only
This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
FCC Statement