Fisher-Price V2758 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires four “AA” batteries (included) for operation.
Adult assembly is required for battery replacement.
Tool required for battery replacement: Phillips screwdriver (not included).
Wipe this toy with a clean cloth. Do not immerse this toy.
This toy has no consumer serviceable parts. Do not take this toy apart.
The car moves best on firm carpet and smooth surfaces.
www.fisher-price.com
V2758

Battery
Replacement
Protect the environment by not•
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
Do not mix old and new batteries or•
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
Insert batteries as indicated inside the•
battery compartment.
Remove batteries during long periods•
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
Never short-circuit the battery terminals.•
Use only batteries of the same or•
equivalent type, as recommended.
Do not charge non-rechargeable•
batteries.
Remove rechargeable batteries from the•
product before charging.
If removable, rechargeable batteries are•
used, they are only to be charged under
adult supervision.
Battery Safety
Information
For best performance, we recommend
replacing the batteries that came with
this toy with four, new “AA” (LR6)
alkaline batteries.
Locate the battery compartment on the•
bottom of the racer.
Loosen the screws in the battery•
compartment door and remove the door.
Remove the exhausted batteries and•
dispose of them properly.
Insert four, new “AA” (LR6)•
alkaline batteries.
Hint: We recommend alkaline batteries
for longer battery life.
Replace the battery compartment door•
and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
If this toy begins to operate erratically,•
you may need to reset the electronics.
Slide the power/volume switch off and
then back on.
When sounds or movement from this•
toy become faint or stop, it’s time for an
adult to change the batteries.
1,5V x 4
“AA” (LR6)

Choose a drive setting for the car. Turn•
the dial on the bottom of the car to:
Loops or Straight Ahead.
Slide the power/volume switch to ON•
with low volume , or ON with high
volume .
Shake the rattle and watch the car•
zoom away!
Hint: The rattle needs to be no more than
three feet from the car. Rattle sounds from
other objects or toys may also activate the
car. The car moves best on firm carpet
and smooth surfaces.
Ready, Set, Go!
Power/Volume Switch
Power/Volume Switch
Baby can turn the roller ball on the top•
of the car to start the action too!
When you are finished playing with•
this toy, slide the power/volume
switch OFF .
Loops
Loops
Turn
Turn
Shake
Shake
Straight Ahead
Straight Ahead

Consumer Information
ICES-003
This Class B digital apparatus complies•
with Canadian ICES-003.
Operation is subject to the following•
two conditions: (1) this device may not
cause harmful interference and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
NMB-003
Cet appareil numérique de la classe•
B est conforme à la norme NMB-003
du Canada.
L’utilisation de ce dispositif est autorisée•
seulement aux conditions suivantes :
(1) il ne doit pas produire de
brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même
si ce brouillage est susceptible de
compromettre le fonctionnement
du dispositif.
FCC Statement (United States Only)
This equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
Reorient or relocate the receiving•
antenna.
Increase the separation between the•
equipment and receiver.
Consult the dealer or an experienced•
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. V2758a-0920
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA