Fisher-Price X7669 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires two AA and two AAA batteries
(batteries included) for operation.
Batteries included are for demonstration purposes only.
Adult assembly is required.
Tool required for battery replacement:
Phillips screwdriver (not included).
X7669
BMD99
fisher-price.com

2
Assembly
• At an angle, fit the bottom of one end of the bridge post onto the building support,
as shown.
• Push to “snap” the top of the same end of the bridge post in place.
• Repeat this procedure to assemble the other end of the bridge to the other building.
The vault door and ramp are designed to break away from the product. If they fall off,
simply follow the steps below to reassemble.
• At an angle, fit the bottom of the vault door into the post on the building. Push to
“snap” the top of the door in place.
• At an angle, fit one side of the ramp into the groove on the building. Push to “snap”
the other side of the ramp in place.
BACK VIEW
FRONT VIEW
Vault Door
Ramp
Ramp

3
Battery Replacement
Building
• Locate the battery compartment door
on the bottom of the building.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the door.
• Remove the exhausted batteries and
dispose of them properly.
• Insert two, new AA (LR6)
alkaline batteries.
• Replace the battery compartment door
and tighten the screw. Do not
over-tighten.
• If the building begins to operate
erratically you may need to reset the
electronics. Slide the power switch off
and back on.
Truck
• Locate the battery compartment door
on the bottom of the truck.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver and remove the door.
• Remove the exhausted batteries and
dispose of them properly.
• Insert two, new AAA (LR03)
alkaline batteries.
• Replace the battery compartment door
and tighten the screw. Do not
over-tighten.
• If the building does not respond when
you press the button on the truck, may
need to reset the electronics. First slide
the power switch on the building off
and then back on. Then, remove the
batteries in the truck and reinstall them.
1,5V x 2
AA (LR6)
We recommend the use of alkaline batteries for longer battery life.
When sounds/lights become faint or stop, it’s time for an adult to change the batteries.
1,5V x 2
AAA (LRO3)

4
CO
N
SU
MER A
SS
I
S
TAN
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
©2013 Mattel. All Rights Reserved.
PRINTED IN CHINA X7669a-0920
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this device must
accept any interference received, including interference that may cause undesired operation.

5
Consumer Information
Battery Safety Information
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.
Care
• Wipe this toy with a clean damp cloth.
Do not immerse.
• This toy has no consumer serviceable
parts. Do not take apart.
ICES-003
This Class B digital apparatus complies
with Canadian ICES-003. Operation is
subject to the following two conditions:
(1) this device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe B est
conforme à la norme NMB-003
du Canada. L’utilisation de ce dispositif
est autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même
si ce brouillage est susceptible de
compromettre le fonctionnement
du dispositif.

Turn the disk to
open and close the
jail door and activate
sounds/lights!
Turn a figure to open
the vault door.
Turn a figure on the disk
to pop-up “flames”. Turn the disk to open the
door and activate siren
lights and sounds!
6 7
• Press the button to shoot “water” on
the flames!
• Slide the power switch on the bottom
of the building ON or OFF .
WARNING
Do not aim at eyes or face.
Only use projectiles supplied
with this toy.
Do not re at point blank range.

• Place the truck near the building.
• Press the button on the truck. Listen
to the building respond.
• After about five minutes of no
activity, the building will go into
“sleep” mode. To wake up the
building, simply turn a disk.
Hints:
• The maximum response range
between the building and the truck is
12 feet (3,7 m).
• Bright sunlight or fluorescent lights
may affect the response range of the
building. Try dimming the light in the
room you are playing in.
• Make sure you have a clear path
between the building and the truck.
8
Action Packed City!
The building recognizes the fire truck and responds!
Additional accessories sold separately and subject to availability.