Flash Furniture TT-TT01122-1A-NAT-GG User manual

Acacia Wood Outdoor
Dining Table with Metal
Legs
Thank you for your purchase!
Customer Service Email: [email protected] | Phone: [phone]
TT-TT01122-1A-NAT-GG
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The
tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.

Have a Question/Concern?
Quality products and first-class customer service are the cornerstone
of long-lasting consumer relationships. We strive toward excellence
in all we do and want you to be completely satisfied with your
purchase. Please contact our exceptional Customer Experience
Agents at the email address or phone number shown below to assist
you with any product questions or issues before requesting a return.
We look forward to serving you in a friendly, efficient manner to
resolve any issues you may have.
Customer Service Email: [email protected]
Customer Service Phone: [phone]
For warranty information, please visit www.belnick.com

1
1
1
1
STEP 1: Connect the Cross Bar (Part B) to the Table Leg Frame (Part A)
using (4) M6x45mm Bolts (Part 1) & (4) Washers (Part 2) from " INSIDE
" surface. Tighten using Allen Wrench (Part 3).
A
B
C
1
3
2
2PCS
1PCS
1PCS
TABLE LEG
FRAME
CROSS BAR
TABLE TOP
M6 X 45mm
(14pcs) Bolts
ø6 X18X1 mm
(14 pcs) Washers
ALLEN WRENCH
INSIDE
Floor glides can be adjusted
for uneven flooring surfaces.
OUTSIDE

1
STEP 2: Attach the assembled legs to the Table Top (Part C) using (10)
M6x45mm Bolts (Part 1) & (10) Washers (Part 2).
Tighten using Allen Wrench (Part 3).
STEP 3
STEP 3: Return table to the upright position
2
3