Flight Model SU-29 50CC User manual

Caution:this plane is not a toy!
Before use ,please carefully read this
manual.
Wing Span:86.6in/2200mm;Flying Weight:3000g;
Wing Area:93sq.dm; Radio:4channels 6servos;
Length:72.8in/1850mm; Engine: 50CC GAS engine;

KIT CONTENS

Insert the hinge into the
wing slot .
Apply AB glue to each side.
Cut away covering film
for the servo.
Install The Aileron Servo

Put the servo into the
hole and adjust the length of
extention.
pull out the servo extension
from main wing.
Install the servo and drill
a hole for tri-horn assemble.

The finished photo as shown.
Adjust the horn and servo
arm.Fix the servo in place
firmly.
Install the main wing by
the carbon jointer, and fasten
the wings by the screws
provided.
Pull the servo extensions
into the fuselage from the
main wing.

Insert the hinge into the
elevator slot .
Apply AB glue to each side of
elevator.
Apply AB glue to each side of
rudder.
Install The Rudder & Elevator

Cut away the film for elevator
pushrod position.
Drill the hole for servo arms.
Loop the cable back through
the brass swage tube as show.

Crimp the brass tube with a
criming tool or pliers.
Attach an metal threaded RC
link to each threaded coupler.
Attach the RC links to the
rudder servo arm and then
attach the servo arm to the
rudder servo as shown.
Attach ball link to rudder
control horn on both sides
of the rudder.
Connect the rudder servo and
control horn with control
links.

Fixup the struts as show.
Mount the tail wheel steering
tiller using two wood screws.
Mount the tail wheel struts
and springs using three wood
screws.
Install the inner wheel collar
next to axle bolt.Tighten the
inner wheel collar in place.
Attach the landing gear to
the wheel.
Install The Landing Gear
Install The Tail Wheel

Use five TP screws to fixup
the landing gear to the
fuselage.
Insert the wing decoration
in the right position.
Apply glue along the edge of
the wing decoration as shown.

Attach the escape-pipe to the
engine.
The process of the fuel tank
assembly.
Put the fuel tank in the right
position.
Glow Engine Installation
Install The Fuel Tank

Use four screws to fixup the
canopy .
Install the cowling with
four TP screws.
ASSEMBLE THE COWLING
ASSEMBLE THE CANOPY

CG & CONTROL SURFACE MOVEMENT

THE FINISHED PHOTO