Flight Model ME-110 Operation instructions

Caution:this plane is not a toy!
Before use ,please carefully read this
manual.
Wing Span:59.1in/1800mm;Flying Weight:3000g;
Wing Area:47sq.dm; Radio:6-7channels 11-12servos;
Length:43.6in/1330mm; Engine:2C 46 twin engine powered;

Gather the carbon joiner,main
wings and other parts.
Apply AB glue
to all sides of each hinges,
to connect the aileron.
Find out and cut the holes for
the servos .
Install The Retract Wheels On Main Wing

Istall front wheel as show.
Use four 3*12 screws to fixup
mechanical retracts.
Assemble Mechanical Retract
servo as show.
Assemble Mechanical Retracts

Istall throttle servo as show.
The finished picture as show.
The other side as show.

Apply AB glue to fixup servo
to the plywood.
Screw the servo to the wood.
Assemble flap servo as show.

Assemble aileron servo
as show.
Assemble the air tube as show.
Use 3*12 screws to fixup air
operated retracts.
Assemble The Air Operated Retracts

Assemble the engine.
Assemble throttle
pushrod as show.
Apply AB glue to gether
right&left wings.
Join the wing
Glow engine installation

Put out the extentions and
air tubes from the main wing.
Fixup the main wing to the
fuselage with two screws.
Apply AA glue to fixup the
decoration plastic to the
fuselage.

Loop the cable back through
the brass swage tube as show.
Crimp the brass tube with a
criming tool or pliers.
Assemble tail wheel swing
construction.
Install The Tail Wheel

Tail wheel collar as show.
Screw four TP screws to
fix up the tail wheel on
the tail of the fuselage.
Find out and cut the holes for
the servos and servo extention
Install Elevator Servo

Apply AB glue to fixup servo
to the plywood.
Screw the servo to the wood.
Insert the 9g servo into the
prepared hole on the elevator.

Connect the servo wire to the
extension then pull out it .
Put the standard servo to the
elevator servo hole.
Link the elevator servo and
tri-horns with pushrod.
elevator servo
tail wheel servo

Sanding the position for
elevator assemble .
Apply instant AB glue to the
edge of fuselage and
stabilizer.
Insert the vertical to the
stabilizer.
Apply instant type glue
to both edge of
stabilizer and vertical.

Dill pushrod hole on the
fuselage.
The elevator rod installation as shown.
Assemble elevator servo
as show.
Another Method To Install Elevator Servo

Use the same method to link
the rudder servo to rudder.
Air operated retract air tube
assemble as show.
Fixup the canopy with TP
screw on each side of the
canopy.
Assemble The Canopy
swich servo
tail wheel
servo

Install the cowling with
four TP screws.
Assemble The Cowling
CG & Control Surface Movement

The Finished Picture