Flight Model F3A Magpie 59" User manual

Wing Span:1500mm/59in;
Flying Weight:2300-2500g;
Wing Area:39.9sq.dm;
Radio:6Channel4Servos;
Length:1537mm/60.5in;
Esc: 60-80A
Prop:16*8;
Motor: Scorpion 4020-16
CAUTION : this plane is not a toy and should be kept away
children under 16 years of age! Before use , please carefully read
this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
performance to full extent .
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.

Main Wings
Connect the aileron and the main wing by hinges.Be sure to apply instant
type glue to both sides of each hinges.
Install the aileron horns in place with AB glue Align the holes in the horns
Cut the servo holes on the bottom of the main wings

Cut the film covering as shown
Insert the fiberglass control horn.
Install the ball links as shown

Put the servo into the hole
Screw the servo with self-tapping screw
Use AB glue to glue the fiberglass control horn
Install the ball links onto the servo arm and

the control horn with stainless push rod supplied.
Connect the main wings and the fuselage with Carbon fiber tube.
Use screw to lock it
Main Landing Gear and Tail Wheel Unit
Gather the parts for the main landing gear.

Use screw to connect the landing gear, wheel pant, nut and wheel
in turn, and finally use a lock nut to lock them.
Install the wheel cover,and fix it up to landing gear with screw.
Cut hole at the Original design hole of the fuselage

Fix up the landing gear on the fuselage bottom with screws.
Stabilizer And Rudder
Gather the parts for the Elevator and rudder servo
As shown

Gather the parts for the Stabilizer.
Put the elevator push rod in the hole
Connect the stabilizer and the fuselage with AB glue

Fix up the stabilizer and elevator with hinges and AB glue.
Connect the stabilizer and push rod
with AB glue
Finished Photo
Cut out the hinges film as shown

Insert the fiberglass control horn into the elevator
Use AB glue to glue it.
Install the elevator servo as shown

Finished photo
Push rod diagram
The steel wire bent into the shape of the seven.

Finished photo
Rudder
Gather the parts for the Rudder
Fix up the rudder with hinges and AB glue.

Drill a hole on the bottom rudder.
Put the tail wheel parts in the hole
use screw to lock the tail wheel onto the fuselage tail.
Finished photo

Cut the servo hole on the fuselage left side
Install the servo and fix it with screws.

Finished photo
The steel wire bent into the shape of the seven.
Connect the servo arm and the control horn with push rod
Insert the cover in the fuselage and fix it with screws.

Install the motor.as shown
Drill a hole on the cowl.as shown
Install the cowl and fix it with screws.

?
Finished photo
CG POSITION & CONTROL THROWS

THE FINISHED PHOTO
Another scheme for choice
Dong Guang Flight Model CO.,Ltd
ADD:No.10,Fu Ning Street,Xian Xi Industrial,Chang An Town,
DongGuan City,Guang Dong Province,China
Tel: [phone]
Fax: [phone]
E-mail:[e-mail]
Web: http:www.flight-model.com
http://flight-model.preview.alibaba.com/