Forest garden TALL GARDEN STORE User manual

Forest Garden Ltd, Unit 288 Hartlebury Trading Estate, Hartlebury, Worcestershire, DY10 4JB
Thank you for choosing this garden building manufactured by the UK's largest manufacturer
of timber garden products. In order to gain the most benefit from it, please note the following:
- This building is pressure treated to ensure the longevity of all timber components and
protect against rot. This may leave a colour difference on some parts that will even out as the
moisture contents stabilize.
- If there are any technical queries with the product, please contact our customer help line on
0333 7777 089 between the hours of 8.30 am and 5.00 pm Monday to Friday.
- In line with your statutory rights, please check all parts prior to assembly, as assembly of
damaged parts may be deemed to be acceptance and this may affect the remedies you are
entitled to. If the product is not constructed in accordance with the instructions, or is altered in
anyway (e.g painted), the manufacturer cannot be held liable for any resulting damage.
- Timber is a natural material. It will shrink and swell as a result of varying moisture content.
- Please keep all plastic bags and small parts away from children in order to reduce the risk of
suffocation.
- This product mut be built on a solid level base.
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
TALL GARDEN STORE
JE
GTS01FP
(Fixing pack)
60mm SCREW Qty 12
Place the two plain side panels against the back end panel as shown. Secure each in place using 3 x 60mm screws, evenly
spaced, screwing through the end panel into the sides.
Place the floor inside so that it site on the bottom battens of the side panels. Secure this in place screwing through the floor into
the battens using 2 x 50mm screws for each side.
Place the shelves so that they also sit on the batten of the side panels and secure in place by screwing through the shelves into
the batten using 2 x 40mm screws for each side. (4 screws for each shelf)
GTS01RFLH
(Roof left hand)
GTS01SH
(Shelf)
GTS01FL
(Floor)
Issue 0214
50mm SCREW Qty 12
MUST PRE DRILL
DRILL POZI DRIVE SCREWDRIVER TAPE MEASURE
HAMMER
2038mm
582mm 922mm
B
Important : Assembly
of this product
requires two adults.
Catch Qty 1
Recommended Tools
GTS01DR
(Door) GTS01BE
(Back End Panel)
GTS01LSH
(Large Shelf)
GTS01RFRH
(Roof right hand)
GTS01DE
(Door End)
GTS01PS
GTS01BE
GTS01PS
GTS01FL
GTS01PS
GTS01SH
GTS01PS
GTS01LSH
GTS01PS
GTS01BE
GTS01PS
(Plain Side)
40mm screw Qty 8
20mm screw Qty 2

Place the two roof sections so that they sit on to the building with the overhang at the front.
Secure each roof section in place by screwing through the front and back panels of the building,
making sure that the screws locate into the battens of the roof sections using 2 x 50mm screws
for each side.
Line the catch up with the receiver making sure the screws will locate into the batten behind. Fix
using 2x20mm screws
Position the door end against the building and secure this in position as you did the back end,
using 3 x 60mm screws, evenly spaced, screwing through the door end into the side panels.
Lift the door and slot the hinges over the pins that are already fixed to the door end.
MUST PRE DRILL
MUST PRE DRILL
GTS01RFLH
GTS01DR
GTS01RFRH
GTS01DE
Warning:
Take care not to cut or trap
fingers when handling and
positioning the roof.