Four Seasons Courtyard SRPH68 User manual

7
ASSEMBLY INSTRUCTIONS
Step 1
Step 2
Step1: To assemble unit-partially open gas chamber
door.Carefully lift dome until entire heat exchange tube
is exposed.
Step 2: After heat exchange tube is fully extended, rotate
counter-clockwise until stopped.
Warning:This appliance requires installation
by a competent person. Proper assembly is
the responsibility of the installer.

ASSEMBLY INSTRUCTIONS
8
2
1
3
Step 3
Warning: This appliance requires installation
by a competent person. Proper assembly is the
responsibility of the installer.
Step3:Fully open gas chamber door. Remove knob from door
and place on control stem.
Step 4
Step4: Locate(3) holes to lock heat exchange tube in place.
Insert (3) included screws into holes.

9
ASSEMBLY INSTRUCTIONS
AA
(not included)
Battery(1.5V)
Step 5
Step 6
+-
AA
Step5: Place battery in compartment below control panel.
Warning:This appliance requires installation
by a competent person. Proper assembly is
the responsibility of the installer.
Step6: Place the gas cylinder (not included) into the base
assembly , and fix it with fixing chain. Attach the regulator
to the cylinder, turn clockwise to tighten it securely, and
then close the door.
Note: Make sure to check for leaks once the cylinder has
been replaced. (Refer to the “check for leaks” section on
page 10)
Tighten

OPERATION
11
y
1. Ensure control knob is in OFF position.
2. Depress control knob and turn counter clockwise to
IGNITE.
3. Continue to depress knob for 30 seconds, listen to ignition
pulse.
4. Then, release knob and turn to adjust heat intensit
5. If pilot does not light, turn knob to OFF and wait 5 minutes
for gas vapors to dissipate, then repeat steps 2 to 4.

OPERATION
12
Note: The burner may be noisy when initially turned on.
To eliminate excessive noise from the burner, turn the control
knob to the Minimum position.
Then, turn the knob to the level of heat desired.
If you experience any ignition problem consult the following
“Troubleshooting”.
These lighting instructions must be followed. An unsafe
condition can occur if they are not followed correctly.

OPERATION
13

14
LOCATING HEADER FOR USE
CAUTION: WHEN CERTAIN MATERIALS OR ITEMS ARE LEFT, ABOVE, BESIDE OR UNDER
THIS HEATER WHILE IN USE, THEY WILL BE SUBJECT TO RADIANT HEAT AND COULD BE
SERIOUSLY DAMAGED.
This heater is primarily used for the heating of
outdoor patios, decks, spas, pools and open
working areas.
Always make sure that adequate fresh air
ventilation is provided. Follow the spacing
tolerances shown in the following figure right at
all times.
This heater must be placed on level, firm
ground.
Never operate in an explosive atmosphere.
Keep away from areas where gasoline or other
flammable liquids or vapors are stored or used.