Framery O User manual

Framery O
Fire safety English Version 1.0

Contents
1 Install the fire alarm.................................................................................... 5
2 Install the customer supplied sprinkler.................................................. 10
2.1 Prepare the installation........................................................................................ 10

1 Install the fire alarm
You can install a wireless or wired alarm. Install the fire alarm onto the ceiling felt at the
back of the pod.
Note: The installation area is approx. 150 mm (6 in) from the rear ABS strip
towards the front of the pod at the straight portion of the ceiling felt.
Note: The maximum recommended screw size is 5x25 mm.
If you intend to install a wired alarm, follow these instructions.
1. Remove the roof body cover.
Framery O Fire safety
[email protected]
5

2. Remove the light.
3. Cut a notch in the ceiling felt. Use a utility knife.
6Framery O Fire safety
[email protected]

4. Install the fire alarm with 4x20 mm (#8 x ¾ in) screws through the ceiling felt.
5. Guide the electrical wiring for the fire alarm under the light and through the notch in the
roof.
Note: Make sure that the wiring can move freely and that it is not stuck
between the edge of the light and the ceiling felt.
Framery O Fire safety
[email protected]
7

6. Guide the electrical wiring out of the notch in the roof.
7. Reinstall the light.
8Framery O Fire safety
[email protected]

8. Cut a notch in the roof cover panel for the electrical wiring.
9. Reinstall the roof body covers.
Framery O Fire safety
[email protected]
9

2 Install the customer supplied sprinkler
Note: To install the piping, see the sprinkler manufacturer's instructions.
2.1 Prepare the installation
Install the sprinkler at the back of the pod.
Note: Use the hole at the back of the pod for the sprinkler head.
1. Cut away the flap on the roof body cover. Use side cutters.
10 Framery O Fire safety
[email protected]