Fresenius Kabi Amika User manual

Amika®is a registered trademark of Fresenius Kabi AG.
Fresenius Kabi Ltd is an authorised user © Fresenius Kabi Ltd.
Fresenius Kabi Limited,
Cestrian Court, Eastgate Way,
Manor Park, Runcorn,
Cheshire WA7 1NT
tel: [phone]
www.fresenius-kabi.com/gb
Date of preparation: October 2023 GB-Ami-2300001
Amika®
ENTERAL NUTRITION PUMP
PICTORIAL REFERENCE GUIDE
Empty battery
Connect pump to
mains supply
immediately.
Pump error alarm
Note the technical
Error code (Err xyz)
and contact your
biomedical
department.
Empty bag/ air in
set alarm
Change feed
container, check
connection to
giving set and
ensure giving set is
fully primed.
Door open alarm
Close pump door.
Ta rget volume
almost reached
message
Continue feeding
or end feeding.
Ta rget volume
reached alarm
End feeding or
proceed to the
next step
Downstream
occlusion alarm
Check that pumpset/
feeding tube is clear
of any occlusion after
the pump, at the
patient side.
Upstream
occlusion alarm
Check that pump
set is clear of any
occlusions between
the container and
the pump
Set installation alarm
Check giving set
position above and
below pump
mechanism and
insert it correctly
Mute alarm (if necessary)
Detect the cause and proceed to the appropriate action
Release alarm Resume feeding
If alarm occurs: Start Reminder
Proceed to next step
or switch pump off.
What to do if...
caring
for
life
FOR
ANY
ENQUIRIES
OR INFORMATION CALL
THE
HOMECARE
24
HOUR FREEPHONE
HELPLINE
NUMBER
0808 100
1990
caring
for life

ENTERAL NUTRITION PUMP PICTORIAL REFERENCE GUIDE
SETTING UP THE PUMP
Close the pinch clamp on the giving set and then
connect to the EasyBag or feed container.
Open the pump door.
Turn the Amika®pump on – pressing
the on/off button.
Place the giving set pinch clamp in line with
the downward arrow until it “clicks” in place.
Press the automatic priming key, and then
press the start button.
Place the giving set tube
straight inside the tube guide.
Set the desired flow rate by
pressing the +/- keys until the
desired volume is reached.
When priming is complete,
press the start button again.
To stop feeding at any point,
press the stop key. When
feeding has finished or your
target volume is reached, press
the stop key.
If you need to reset the
progress bar after target
volume is reached, press the
stop key for 2-3 seconds.
To switch off the pump
press the on/off button
until the countdown is
completed.
Connect the giving set to the
patient’s enteral feeding tube.
Press the start key to
start feeding.
Set the target volume by
pressing the +/- keys until the
desired volume is reached.
Close the door, push down the
lever to lock it firmly in place.
01 02
06
03
14
07
04
0908
11 12 13
05
10