Fritz! 310 User manual

FRITZ ! WLAN Repeater 310
Connecting with CYTA ZTE Modem using WPS Quick connection
Prior initiating the connection check that the ZTE Modem is in operation and the
Fritz WLAN Repeater 310 is plugged on a power outlet close to ZTE. The Repeater
will restart, about two minutes after switched ON and the Leds for Power and
WLAN will go steadily ON…
1. Press the WPS button on the Repeater for approximately 6 seconds until the
Led WLAN starts flashing and then depress it…

2. Then Press the WPS button on ZTE for approximately one second…
3. The Led WPS on ZTE starts flashing…

4. Connection between ZTE and Repeater is initiated. After the connection is
established the Repeater takes the SSID name the ZTE Modem has and all Leds
on it will go ON…
5. Unplug now the Repeater from the socket outlet and plug it on another one in
order to extend the Wi-Fi coverage from ZTE Modem in your home. Check
that at the new position the signal strength from ZTE should have a
considerable level. At least two Leds from all five showing the signal strength
must be ON.
USEFULL INFORMATION
Download from play Store the FRITZ!AppWLAN application which gives information
concerning the Wi-Fi network your phone is connected to, either ZTE or Fritz
Repeater.
Sometimes when moving around your home, your phone may not get automatically
connected to the highest signal strength Wi-Fi network. This can be achieved either
using the application stated above or by switching OFF and ON the Wi-Fi from
phone settings.