When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury
to persons, including the following:
1. Fully read through the operation and assembly instructions before operating the heater. Be sure to keep this manual in a safe
place for future reference. If you pass the heater on, pass on the instructions too.
2. This heater is designed for outdoor use only.
3. Confirm that the supply voltage indicated on the rating plate of the heater corresponds to the local voltage before you connect
the heater. The power supply to the heater should correspond to the relevant regulations of the power supply companies and
the regional constructor regulations.
4. This heater is hot when in use. To avoid burns do not let bare skin touch hot surfaces. If provided, use handles when moving
this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m)
from the front of the heater and keep them away from the sides and rear.
5. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating
and unattended.
6. Always unplug heater when not in use.
7. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, or has been dropped or damaged in
any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
8. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may
fall into a bathtub or other water container.
9. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or similar coverings. Arrange cord away from
traffic area and where it will not be tripped over. Do not let the cord hang over edge of a table or counter, or touch hot surfaces.
10. To disconnect heater, turn controls to off, then remove plug from outlet.
11. Remove the plug from the power outlet and wait until the heater is sufficiently cooled off before cleaning.
12. Connect to properly grounded outlets only.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or
damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where
openings may become blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock or
injury to persons.
17 Always plug the heater into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tab (outlet/power strip).
18. This heater is for use on -
120volts. The
cord
has
a
plug
as
show
n
at
A
in Figure O. An adaptor as shown in Figure 0 is available for connecting
three-blade grounding type plugs to two-slot receptacles. The green
grounding lug extending from the adaptor must be connected to a
permanent ground such as a properly grounded outlet box.The adaptor
should not be used if a three-slot grounded receptacle is available.
SAVETHESE INSTRUCTIONS
grounding
pin
(C)
adapter
Figure 0
Grounding Methods
•
II
(A)
grounding
means grounding
pin
2
metal screw
cover of grounded
outlet box
(B)
IMPORTANT INSTRUCTIONS
When using electr ical appliances, basic precautions should always be fol lowed to reduce the risk of fire, electri cal shock and injury
to persons, incl udi ng the following:
1. Full y read through the operation and assembly instructi ons before operating the heater . Be sure to keep this manual in a safe
plac e for futur e reference. If you pass the heater on, pass on the instr uctions too.
2. This heater is designed for outdoor use only.
3. Confir m that the supply voltage indicated on the rating plate of the heater corresponds to the local voltage befor e you connect
the heater. The power supply to the heater should correspond to the relevant r egulations of the power supply companies and
the regional constructor regulations.
4. This heater is hot w hen in use. To avoid burns do not let bare skin touch hot surfaces. If provided, use handles when movi ng
this heater . Keep com bustible materials, such as furniture, pill ows, beddi ng, papers, clothes and curtains at least 3 feet (0.9m)
from the front of the heater and keep them away from the sides and rear.
5. Extrem e caution is necessary when any heater is used by or near chi ldren or invalids and w henever the heater is left operating
and unattended.
6. Always unplug heater when not in use.
7. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, or has been dropped or damaged in
any manner. Return heater to authorized service facil ity for examination, electr ical or mechanical adjustm ent, or repair.
8. This heater is not intended for use in bathrooms, laundry areas and sim ilar indoor locations. N ever locate heater where it may
fall into a bathtub or other water container.
9. Do not run cord under carpeting. Do not cover cord with throw rugs, r unners or similar coverings. Arr ange cor d away from
traffic ar ea and w her e it will not be tr ipped over. Do not let the cord hang over edge of a table or counter , or touch hot surfaces.
10. To disconnect heater, turn controls to off, then remove plug from outlet.
11. Remove the plug from the power outlet and wait until the heater is sufficiently cooled off before cl eaning.
12. Connect to properly gr ounded outlets only.
13. Do not insert or allow foreign obj ects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or
damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust i n any manner. Do not use on soft surfaces, like a bed, where
openings m ay become blocked.
15. A heater has hot and arcing or sparking parts i nside. Do not use it in
areas where gasoli ne, paint or flammable li quids are used or stor ed.
16. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electr ic shock or
injury to persons.
17 Always plug the heater into a wall outlet/receptacle. Never use with an
extens ion cor d or relocatable power tab (outlet/power strip).
18. This heater is for use on -
120vol ts. The
cord
has
a
plug
as
show
n
at
A
in Fi gur e O. An adaptor as shown in F igure 0 is availabl e for connecting
three-blade grounding type plugs to two-sl ot receptacles. The green
grounding lug extending from the adaptor m ust be connected to a
permanent gr ound such as a properly grounded outlet box.The adaptor
should not be used if a three-slot grounded receptacl e is available.
SAVETHESE INSTRUCTIONS
grounding
pin
(C)
adapter
Figure 0
Gr ounding Methods
•
II
(A)
grounding
means grounding
pin
2
Hot li ne: (+86) 574 87111340 Web: www.holite.com Email: mczheng©holite.com
metal screw
cover of gr ounded
outlet box
(B)
IMPORTANT INSTRUCTIONS - PLEASE READ CAREFULLY
