FrSky FAS7 ADV Lite User manual

FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS7 ADV Lite
Connect the output Port of the sensor to the receiver, select FBUS/S.Port on the receiver setup tool, the ADV
sensors in either mode can be automatically matched.
Protocol Smart Matching
FrSky ADVANCE (ADV) series has comprehensive sensor types and enhanced the performance and capability
of the original sensor line, all ADV sensors fully support FBUS protocol and they are also S.Port compatible. With
the FBUS protocol, the ADV sensors can be seamlessly paired with the FBUS-capable receiver and further
simplifying the builds setup.
The FAS7 ADV Lite current sensor comes with a small dimension that can measure current up to 7 Amps with an
accuracy tolerance of +/- 0.1 Amp. This is a really useful sensor, an obvious choice for accurate measurement of
low current loads on Glider servos.
Introduction
Overview
13 mm
20 mm
VIN
VOUT
RED
GREEN
Button
To other FrSky FBUS/S.Port
capable Sensor
RECEIVER
To the FrSky receivers
FrSky Current Sensor – FAS7 ADV Lite is compatible with FrSky FBUS or S.Port capable receivers. For more
details, please refer to corresponding receiver instruction manual.
Set Up
● Dimension: 20*13*6.1mm (L*W*H)
● Weight: 1.9g
●
Measurement range: 0-7 A (1%)
●
Current consumption: 11mA@5V
● Maximum safe current: 7A
● Measuring voltage: ≤32V
● Supplying voltage (S.Port): 3.5-10V
● Compatible with FBUS/S.Port protocol
Specifications

FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS7 ADV Lite
FBUS
NO
YES
LED Status
Flash slowly
Flash quickly
S.Port
YES
NO
The Battery and ESC should be connected to BAT port and ESC port correspondingly and make sure the polarity
is correct. FrSky is not responsible for any damage caused by wrong polarity connection.
LED Status
Each type of FrSky sensors has its unique physical ID. The default physical ID for this sensor is 02. The ID
number could be changed by ETHOS or FreeLink App.
ID Set Up
Note: All sensors could daisy chain with each other through their Smart Port.
Other FrSky FBUS/S.Port capable sensors include new ADV series Variometer Sensor, GPS Sensor, RPM
Sensor, Airspeed Sensor, and so on. (NON-ADV series sensors only support working via S.Port.)
Warning: Install FrSky Current Sensor – FAS7 ADV Lite on any appropriate surface of the airframe that
stays away from water, vibration, or fuel.