FrSky FAS7 ADV User manual

Thank you for purchasing FrSkyCurrent Sensor – FAS7 ADV. It is designed for FrSky Smart Port (compatible with
SPORT/FBUS protocol)
enabled system, and can measure Current (A) and Battery Voltage (V) when connected
between a Battery. In order to fully enjoy the benefit of it, please read the instruction manual carefully and set up the
device as described below.
Introduction
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS7 ADV
Note: All instructions, warranties and other collateral documents are subject to change at the sole
discretion of FrSky Electronic Co., Ltd. For further information, please visit www.frsky-rc.com
and click the support tab for this product.
Specifications
• Dimension: 32.6×16×6.1mm (L×W×H)
• Weight: 2.1g
• Measurement range: 0-7A (1%）
• Current consumption: 11mA@5V
• Maximum safe current: 7A
• Measuring voltage: ≤32V
• Supplying voltage (S.Port): 3.5-10V
• Compatible: FrSky Smart Port enabled receivers (compatible with SPORT/FBUS protocol)
Connect the output Port of the sensor to the receiver, select SPORT/FBUS on the receiver setup screen, the sensor
will automatically recognize.
Protocol switching
FrSky Current Sensor – FAS7 ADV is compatible with FrSky Smart Port enabled receivers. For more details, please
refer to corresponding receiver instruction manual.
Set Up
To other FrSky
S.Port Enabled Sensor
RECEIVER
To the S.Port of
FrSky receivers
VDCG
Overview
16 mm
25 mm
Button
RED
GREEN
S.Port
VIN
GND
VDCG
VIN
VOUT

FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS7 ADV
The Battery and ESC should be connected to BAT port and ESC port correspondingly and make sure the polarity is
correct. FrSky is not responsible for any damage caused by wrong polarity connection.
LED Status
FBUS
NO
YES
LED Status
Flash slowly
Flash quickly
S.Port
YES
NO
Other FrSky S.Port
enabled sensors include new Smart Port enabled Variometer Sensor, GPS Sensor, RPM
Sensor, Airspeed Sensor, and so on.
ID Set Up
Note: All sensors could daisy chain with each other through their Smart Port.
Each type of FrSky sensors has its unique physical ID. The default physical ID for this sensor is 02. The ID number
could be changed by Free Link (Windows/android/ios)
Warning: Install FrSky Current Sensor – FAS7 ADV on any appropriate surface of the airframe that
stays away from water, vibration, or fuel.