FrSky PS30 ADV User manual

FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Instruction Manual for FrSky
Pressure Sensor - PS30 ADV
Version
1.0
Note: All instructions, warranties and other collateral documents are subject to change at the sole
discretion of FrSky Electronic Co., Ltd. For further information, please visit www.frsky-rc.com and
click the support tab for this product.
Thank you for purchasing FrSky Pressure Sensor - PS30 ADV. It is designed for FrSky Smart Port enabled system,
and can measure pressure. In order to fully enjoy the benefit of it, please read the instruction manual carefully and
set up the device as described below.
Introduction
Specifications
• Dimension: 37*20*7mm (L×W×H)
• Weight: 2.9g
• Operating voltage: 4-10V
• Current drain: 5mA@5V
• Pressure measurement
- Measurement range: 0~30 Bar (435 psi)
- Overpressure: 50 Bar
• Safety pressure (T-Connector): 15Bar
• Compatible with FBUS/S.Port protocol
Overview
20mm
27mm
PRESS
29.5mm
35.5mm
4mm
4mm
5mm
4mm
5mm
33.5mm
46mm
6mm
PRESS
Measured Range:
0~30 Bar (435 psi)

FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Instruction Manual for FrSky
Pressure Sensor - PS30 ADV
Version
1.0
Connect the output Port of the sensor to the receiver, select S.Port/FBUS on the receiver setup screen, the sensor
will automatically recognize.
LED Status
FBUS
NO
YES
LED Status
Flash slowly
Flash quickly
S.Port
YES
NO
Warning: 1. Do not disassemble the pressure measuring head！
2. Keep the circuit board away from water, vibration, or fuel.
Set Up
Pressure sensor - PS30 ADV is compatible with FrSky Smart Port enabled receivers. Other FrSky S.Port enabled
sensors include new Smart Port enabled Variometer Sensor, GPS Sensor, RPM Sensor, Airspeed Sensor, and so
on. For more details, please refer to the corresponding receiver instruction manual.All sensors could daisy chain
with each other through their Smart Port.The ID number of the device could be changed by Free Link (Windows/an-
droid/ios).
To other FrSky FBUS/S.Port
Enabled Sensor To the FrSky receivers
Connect the T-Connector to the pressure measuring head.