Fuji Xerox DocuPrint P225 d User manual

Unpack the machine and check the components
Read the Safety Guide first, then read this Quick Setup Guide for the correct installation
procedure.
NOTE:
• The components included in the box and the AC power plug may differ depending on your
country.
• The available connection interfaces vary depending on the model.
• The illustrations in this Quick Setup Guide are based on the DocuPrint P265 dw.
• The USB cable is a standard accessory.
Network cable
Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T or
100BASE-TX Fast Ethernet Network.
Remove the packing materials and install the toner cartridge
Load paper in the paper tray
Connect the machine to your computer/mobile device
Connect the power cord and turn on the machine
Select your language (Only for certain models)
A
Drum Unit
(Pre-installed)
AC Power Cord
(only for certain models)
Quick Setup Guide
B
USB Interface Cable Inbox/Starter Toner
Cartridge
CD‑ROM Safety Guide
1. Press ▼ or ▲ to select General Setup, and then press OK.
2. Press OK to select Local Language.
3. Press ▼ or ▲ to select your language, and then press OK.
A
B
B
A
A
B
3
4
2
5
1
Adjust the paper guides.
• Windows®PC with a CD-ROM drive, go to step 5A
• Windows®PC without a CD-ROM drive, go to step 5B
• Macintosh, go to step 5B
• Mobile device users with a WPS/AOSS-supported access point/router, go to step 5C
Back Front
Remove the orange part. Remove the orange part.
Quick Setup Guide
DocuPrint P225 d / DocuPrint P265 dw
LJB476001-00
604E 77060 MB3547E2-1 (Edition 1)
September 2014
Copyright © 2014 by Fuji Xerox Co., Ltd.
Fuji Xerox Co., Ltd. Printed in Vietnam

Configuration using the CD-ROM (Windows®)
Follow the on-screen
instructions until the
Connection Type screen
appears.
Finish
5A
Download the full driver and software package by visiting the Fuji Xerox website at http://www.fujixeroxprinters.com/.
After you download the driver and software package, follow the on-screen instructions until the Connection Type screen appears. Refer to 5A Configuration using the CD-ROM
(Windows®).
If your wireless LAN access point/router supports automatic wireless (one-push) setup (WPS/AOSS™), you can set up your machine without using a computer.
Connection Type
For USB Connection
For Wired Network Connection
Connect a network cable first.
For Wireless Network Connection
We recommend preparing a USB cable
to use temporarily during the wireless
setup.
Follow the on-screen
instructions to continue
installation.
NOTE:
If connection is unsuccessful, repeat this step.
One-push wireless setup for mobile devices (Wireless models only)
Wireless Network Connection
[Recommended]
Select this option if you have a USB cable to
use temporarily for wireless setup.
Select this option if you do not have a USB cable.
Follow the on-screen
instructions to continue
installation.
NOTE:
If connection is unsuccessful, repeat this step.
Configuration without using the CD-ROM (Windows®without CD-ROM drive or Macintosh)
5C
5B
Wireless setup is now complete.
Finish
Press the WPS or AOSS™ button on your
wireless LAN access point/router.
Press the WiFi button on your machine.
NOTE:
If the Fuji Xerox screen does not appear automatically, go to Computer.
(For Windows®8: click the (File Explorer) icon on the taskbar, and then go to Computer.)
Double-click the CD-ROM icon, and then double-click start.exe.
604E 77060 MB3547E2-1 LJB476001-00