Fujitsu ASYA30LCC User manual

En-12
CLEANING AND CARE
●Before cleaning the indoor unit, be sure to turn it off and disconnect the Power Supply Cord.
●Be sure the Intake Grille (Fig. 1 8) is installed securely.
●When removing or replacing the air filters, be sure not to touch the heat exchanger, as personal
injury may result.
CAUTION!
Cleaning the Intake Grille
1. Remove the Intake Grille.
1Place your fingers at both lower ends of the grille
panel, and lift forward; if the grille seems to catch
partway through its movement, continue lifting up-
ward to remove.
2Pull past the intermediate catch and open the Intake
Grille wide so that it become horizontal.
2. Clean with water.
Remove dust with a vacuum cleaner; wipe the indoor
unit with warm water, then dry with a clean, soft cloth.
3. Replace the Intake Grille.
1Pull the knobs all the way.
2Hold the grille horizontal and set the left and right
mounting shafts into the bearings at the top of the
panel.
3Press the place where the arrow on the diagram indi-
cates and close the Intake Grille.
Cleaning the Air Filter
1. Open the Intake Grille, and remove the air
filter.
Lift up the air filter’s handle, disconnect the two lower
tabs, and pull out.
2. Remove dust with a vacuum cleaner or by
washing.
After washing, allow to dry thoroughly in a shaded place.
3. Replace the Air Filter and close the Intake
Grille.
1Align the sides of the air filter with the panel, and push
in fully, making sure the two lower tabs are returned
properly to their holes in the panel.
2Close the Intake Grille.
(For purposes of example, the illustration shows the indoor
unit without Intake Grille installed.)
●Dust can be cleaned from the air filter either with a vacuum
cleaner, or by washing the filter in a solution of neutral
detergent and warm water. If you wash the filter, be sure
to allow it to dry thoroughly in a shady place before rein-
stalling.
●If dust is allowed to accumulate on the air filter, airflow
will be reduced, lowering operating efficiency and increas-
ing noise.
●During periods of normal use, the Air Filters should be
cleaned every two weeks.
●Don't operate the air conditioner with being opened the
intake grille.
●When used for extended periods, the indoor unit may accumulate dust inside, reducing its performance.We recommend
that the indoor unit be inspected regularly, in addition to your own cleaning and care. For more information, consult
authorized service personnel.
●When cleaning the indoor unit’s body, do not use water hotter than 40 °C, harsh abrasive cleansers, or volatile agents like
benzene or thinner.
●Do not expose the indoor unit’s body to liquid insecticides or hairsprays.
●When shutting down the indoor unit for one month or more, first allow the fan mode to operate continuously for about
one-half day to allow internal parts to dry thoroughly.
Intake Grille
Air filter handle
Air filter (Right & Left)
Mounting
shaft
Bearing
Knob
Mounting
shaft
Knob
1
2
31
2
3
Hooks(two places)
Hooks(two places)

En-13
Air Cleaning Filter Installation
1. Open the Intake Grille and remove the Air
filters.
2. Attach the air cleaning filter to the frame
of the front panel.
●Attach the filter on the inside of the tabs (6 places) so
as not to stick out.
(In the above figure, the intake grille is omitted for
the explanation)
3. Install the two Air filters and close the
Intake Grille.
●Don't operate the air conditioner with being opened
the intake grille.
●When air cleaning filters are used, the effect will increased
by setting the fan speed to “High”.
2. Remove the air cleaning filters attached
to the frames of the front panel.
3. Replace them by two new Air cleaning
filters.
1Remove the old air cleaning filters in reverse order of
their installation.
2Install in the same way as for installation of the air
cleaning filter set.
4. Install the two Air filters and close the
Intake Grille.
●Don't operate the air conditioner with being opened
the intake grille.
About the Air Cleaning Filters
POLYPHENOL CATECHIN AIR CLEANING FILTER (one sheet)
●The Air Cleaning Filters are disposable filters. (They can
not be washed and reused.)
●For storage of the Air Cleaning Filters, use the filters as
soon as possible after opening the package.
(The air cleaning effect decreases when the filters are left
in the opened package)
●Generally, the filters should be exchanged about every
three months.
Please buy designed air cleaning filters (UTR-FA16) (Sold
separately) to exchange the used dirty air cleaning filter.
[Negative air ions deodorizing filter (one sheet) — light blue]
●The filter should be exchanged about every three years
so as to maintain the deodorizing effect.
●Filter frame is not a one-off product.
Please buy designed deodorizing filter (UTR-FA16-2) (Sold
separately) when exchanging the filter.
Maintenance of Deodorizing Filters
In order to maintain the deodorizing effect, please clean the
filter in the follow way once three months.
1Remove the deodorizing filter.
2Clean with water and dry in the air.
1) Flush the filter with high-pressure hot water until
the surface of the filter is covered with water. Please
flush with diluent neutral detergent.
Never wash by reaming or rubbing, otherwise it
will damage the deodorizing effect.
2) Rinse with water flow.
3) Dry in shade.
3Reinstall the deodorizing filter.
CLEANING AND CARE
Replacing dirty Air cleaning filters
Replace filters with the following components (purchased
separately).
●
POLYPHENOL CATECHIN AIR CLEANING FILTER : UTR-FA16
●Negative air ions deodorizing filter: UTR-FA16-2
1. Open the Intake Grille and remove the Air
filters.
Air cleaning filter frame
Tabs (6 places)
Tabs
(6 places)
Air filter
Air filter
Air cleaning filter frame