Fujitsu IMAGE SCANNER FI-486PRFR User manual

Japanese
English
fi-486PRFR Imprinter
Operator’s Guide
Operator’s Guide



P3PC-E377-01XA

English
fi-486PRFR Imprinter
Operator’s Guide
Operator’s Guide

i
Thank you for purchasing the fi-486PRFR Imprinter.
The fi-486PRFR is the fi-4860C image scanner option.
The fi-486PRFR and the fi-486PRRE can be installed in the fi-4860C image
scanner together.However, they cannot be used at a time.Either fi-486PRRE or
fi-486PRFR can be used during scanning.
fi-486PRFR
The fi-486PRFR prints on the front side of documents.
Printing is done prior to scanning a document and the printed
characters are scanned and included in the scanned image.
About this manual
The contents of this manual are as follows.
1. PREPARATIONS
This chapter explains the contents of the imprinter package and the
part names.
2. BASIC OPERATIONS
This chapter describes how to use the imprinters.
3. DAILY CARE
This chapter describes how to clean the imprinter and the related area
of the scanner.
4. REPLACING PRINT CARTRIDGE
This chapter explains how to replace the Print cartridge and reset the
Ink remain counter.
5. PRECAUTION
This chapter explains important details for ensuring the correct use of
the products.
ATTENTION
The fi-486PRFR installation should be done by a trained service engi-
neer.
INTRODUCTION

ii
6. ERROR MESSAGES
This chapter explains the error messages and the recovery process.
7. SPECIFICATIONS
This chapter describes the specifications of the fi-486PRFR imprinter
option.
This manual provides necessary information to make the best use of the
fi-486PRFR.
August, 2002

iii
■
■ ■
■ Revisions
FCC declaration
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
Canadian DOC Regulations
This digital apparatus does not exceed the Class A limit for radio noise emissions
from digital apparatus set out in the Radio interference Regulations of the Canadian
Department of Communications.
Le pésent appareil numérique n’ément pas de bruits radioélectriques dépassant les
limites applicables aux appareils numériques de la classe A prescridtes dans le
Réglesment sur le brouillage radioélectrique dicté par le ministere des
Communications du Canada.
Cet appareil numérique de la classe A est conformme à la norme NMB-003 du
Canada.
CAUTION
Changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user’s authority to operate
the equipment.
ATTENTION
•The use of a shielded interface cable is
required to comply with the Class A limits
of Part 15 of FCC rules. The length of the
SCSI interface cable must be 1.5 meters
(5 feet) or less.
•The length of the AC cable must be 3
meters (10 feet) or less.

iv
International ENERGY STAR® Program
As an ENERGY STAR®Partner, PFU LIMITED has determined
that this product meets the ENERGY STAR®guidelines for energy
efficiency.
The International ENERGY STAR®Office Equipment Program is
an international program that promotes energy saving through the penetration of
energy efficient computers and other office equipment. The program backs the
development and dissemination of products with functions that effectively reduce
energy consumption. It is an open system in which business proprietors can
participate voluntarily. The targeted products are office equipment such as
computers, monitors, printers, facsimiles, copiers, scanners, and multifunction
devices. Their standards and logos ( ) are uniform among participating
nations.
Use in High-safety Applications
This product has been designed and manufactured on the assumption that it will be
used in office, personal, domestic, regular industrial, and general-purpose
applications. It has not been designed and manufactured for use in applications
(simply called "high-safety applications" from here on) that directly involve serious
danger to life and health when an extremely high degree of safety is required, for
example, in the control of nuclear reactions at nuclear power facilities, automatic
flight control of aircraft, air traffic control, operation control in mass-transport
systems, medical equipment for sustaining life, and missile firing control in weapons
systems, and when provisionally the safety in question is not ensured. The user
should use this product without adopting measures for ensuring safety in such high-
safety applications. PFU LIMITED assumes no liability whatsoever for damages
arising from use of this product by the user in high-safety applications, and for any
claims or compensation for damages by the user or a third party.
All Rights Reserved, Copyright© PFU LIMITED 2002.

v
■
■ ■
■ Preface
Safety Precautions
This manual describes important details for ensuring the safe and correct use of
this product. Thoroughly read this manual before you start to use this product. In
particular, be sure to read and fully understand the Safety Precautions described in
this manual before you use this product.
Also, store this manual in a safe place so that it can be easily referred to during use
of this product.
Warning Indications Used In This Manual
This manual uses the following indications to ensure safe and correct use of this
product, and to prevent possible danger and injury to the operator and other
persons.
CAUTION
This indication alerts operators to an operation that, if not
strictly observed, may result in severe injury or death.
WARNING
This indication alerts operators to an operation that, if not
strictly observed, may result in safety hazards to personnel
or damage to equipment.

vi
Symbols Used In This Manual
This manual uses the following symbols in explanations in addition to warning
indications.
ATTENTION
This symbol alerts operators to particularly important information.
Be sure to read this information.
HINT
This symbol alerts operators to helpful advice regarding opera-
tion.
A TRIANGLE symbol indicates that special care and attention is
required.
The drawing inside the triangle shows the specific caution.
A CIRCLE with a diagonal line inside shows action which users
are not allowed to do.The drawing inside or under the circle shows
the specific action that is not allowed.
R
Outline characters on a colored background shows instructions
users should follow. It may include the drawing which shows the
sepecific instruction.

vii
■
■ ■
■ Safety Precautions
WARNING
The following describes important warnings described in this manual.
Do not install in locations subject to oil smoke, steam, humidity, and
dust.
Do not use the scanner if you smell strange odor.
Do not install the scanner in locations subject to oil smoke, steam,
humidity, and dust. Doing so might cause fire or electric shock.
If you sense heat coming from devices or detect other malfunctions
such as smoke, strange smells or strange noises, immediately press
down the power button to turn off the scanner and then disconnect
its power plug.
Make sure that the smoke has disappeared, and then contact the
agent where you bought the scanner.

viii
Do not allow liquids to get inside the scanner.
Do not insert or drop foreign metal objects in to the scanner.
Do not scan wet document or document with paper clips.
Do not splash or allow the scanner to get wet.
If foreign objects (water, small metal objects, liquids, etc.) get inside
the scanner, immediately press down the power button to turn off the
scanner and disconnect the power plug from the power outlet.
Then contact the agent where you bought the scanner or Mainte-
nance Service Center.
Pay particular attention to this warning in households where there
are small children.

ix
CAUTION
The following describes important cautions described in this manual.
Protect the scanner from static electricity.
Do not use aerosol sprays near the scanner.
Do not install the scanner in the direct sunlight.
Install the scanner away from strong magnetic fields and other
sources of noise. Also, protect the scanner from static electricity as
this might cause the scanner to malfunction.
Do not use aerosol sprays, for example, to clean the scanner. Air
sprayed from aerosol sprays causes dirt and dust to enter the
scanner, resulting scanner failure and malfunction.
Do not install the scanner in the direct sunlight or near heating
apparatus. Doing so might cause heat to build up inside the scanner,
causing fire or scanner trouble. Install the scanner in a well-
ventilated location.

x
■
■ ■
■ Fujitsu Group Offices
Please send your comments on this manual or on Fujitsu products to the following
addresses:
FUJITSU COMPUTER PRODUCTS OF
AMERICA, INC.
2904 Orchard Parkway, San Jose, CA
95134-2009, U.S.A.
Phone: [phone];
(1-408)432-6333
Technical Assistance Center:
(1-800)626-4686
Fax: [phone]
Website: http://www.fcpa.com/
E-mail: [e-mail]
FUJITSU CANADA, INC.
2800 Matheson Boulevard East,
Mississauga, Ontario L4W 4X5, Canada
Phone: [phone]
Fax: [phone]
Website: http://www.fujitsu.ca/
E-mail: [e-mail]
(For Sales Questions)
[e-mail]
(For technical questions)
FUJITSU EUROPE LTD.
Hayes Park Central, Hayes End Road,
Hayes Middlesex UB4 8FE, U.K.
Phone: [phone]
Fax: [phone]
Website: http://www.fujitsueurope.com/
E-mail: [e-mail]
FUJITSU DEUTSCHLAND GMBH.
Frankfurter Ring 211, 80807 München
40, Germany
Phone: [phone]
Fax: [phone]
Website: http://de.fujitsu.com/
E-mail: [e-mail]
FUJITSU ITALIA S.p.A.
Via Nazario Sauro, 38
20099 Sesto San Giovanni (Milan), Italy
Phone: [phone]
Fax: [phone]
Website: http://www.fujitsu-europe.com/
FUJITSU ICL ESPAÑA, S.A.
Camino Cerro de los Gamos, 1 28224,
Pozuelo de Alarcon, Madrid, Spain
Phone: [phone]
Fax: [phone]
Website: http://www.fujitsu-europe.com/
E-mail: [e-mail]
FUJITSU AUSTRALIA LTD.
Fujitsu House 2 Julius Avenue
North Ryde, N.S.W 2113 Australia
Phone: [phone]
Fax: [phone]
Website: http://au.fujitsu.com/
FUJITSU ASIA PTE.LTD.
20 Science Park Road, #03-01, Tele
Teck Park Singapore Science Park II,
Singapore 117674
Phone: [phone]
Fax: [phone]
Website: http://sg.fujitsu.com/
E-mail: [e-mail]

xi
Screen Examples In This Manual
The screen examples in this manual are subject to change without notice in the
interest of product improvement.
FUJITSU TAIWAN LTD.
19th Fl., No39, Sec.1,Chung-hwa Rd.,
Taipei, Taiwan R.O.C.
Phone: [phone]
Fax: [phone]
Website: http://fw.fujitsu.com/
FUJITSU HONG KONG LTD.
10/F., Lincoln House, 979 King's Road,
Taikoo Place, Island East, Hong Kong
Phone: [phone]
Fax: [phone]
Website: http://hk.fujitsu.com/
E-mail: [e-mail]
FUJITSU SYSTEMS BUSINESS
(THAILAND) LTD.
12th Fl., Olympia Thai Tower, 444
Rachadapisek Road, Samsennok,
Huay kwang, Bangkok 10320, Thailand
Phone: [phone]
Fax: [phone]
Website: http://th.fujitsu.com/
FUJITSU KOREA LTD.
5-11 Fl., Coryo Finance Center Building,
Youido-Dong 23-6, Young DungPo-gu,
Seoul, Korea, 150-010
Phone: [phone]
Fax: [phone]
Website: http://kr.fujitsu.com/
E-mail: [e-mail]
FUJITSU MALAYSIA SDN.BHD.
7th FL., Wisma Damansara, Jalan
Semantan 50490 Kuala Lumpur,
MALAYSIA
Phone: [phone]
Fax: [phone]
Website: http://my.fujitsu.com/
FUJITSU PHILIPPINES, INC
2nd Fl., United Life Building, Pasay
Road, Legaspi Village Makati,
Metro Manila, Philippines
Phone: [phone]
Fax: [phone]
Imaging Products Division,
PFU LIMITED
Solid Square East Tower, 580 Horikawa-
cho, Saiwai-ku, Kawasaki-shi,
Kanagawa 212-8563, Japan
Phone: [phone]
Fax: [phone]
Website: http://
imagescanner.fujitsu.com/
E-mail: scan[email protected]itsu.com
PFU LIMITED
(Corporate headquarters)
Nu 98-2 Unoke, Unoke-machi,
kahoku-gun, Ishikawa 929-1192, Japan
Phone: [phone]
Fax: [phone]

xii
If the actual displayed screen differs from the screen examples in this manual,
operate by following the actual displayed screen referring to the User's Manual of
the scanner application you are using.
Furthermore, the screenshots in this manual are for the FUJITSU TWAIN32
scanner driver and the Image Capturing Software Utilities "ScandAll 21" for
Microsoft®Windows®.

xiii
1 PREPARATIONS ...........................................1
Checking the Contents of the Imprinter Package ..............................2
Outer View .........................................................................................3
2 BASIC OPERATIONS ...................................5
Installing the Print Cartridge ..............................................................6
Adjusting Print Position ......................................................................9
Setting Imprinter ..............................................................................11
3 DAILY CARE ...............................................13
4 REPLACING PRINT CARTRIDGE ..............19
Replacing the Print Cartridge ..........................................................20
Reset the remaining ink counter of imprinter ...................................23
5 PRECAUTION .............................................25
6 ERROR MESSAGES ...................................27
7 SPECIFICATIONS .......................................29
CONTENTS

xiv

1
1PREPARATIONS
This chapter explains how to prepare the imprinter, fi-486PRFR for
use.
1.1 Checking the Contents of the Imprinter Package ..............2
1.2 Outer View..............................................................................3

21.1Checking the Contents of the Imprinter Package
1.1 Checking the Contents of the
Imprinter Package
Please confirm that all of the following parts are included in the package. If any parts are
missing or defective, contact the FUJITSU Scanner dealer where you purchased the
product.
Handle the imprinter and the accessories with care.
Imprinter and Accessories
oImprinter oPrint Cartridge oOperator's Guide
oInstallation screws
(Qty 2) oPositioning seal oPCB unit
oGlass sheet guide oOperation instruction
label