Furious FPV Acrowhoop v2 Assembly instructions

1
https://furiousfpv.com
How to do connect FRSKY DJT Module with Acrowhoop v2.
Step1: Choose Mode Module to D8.
On the DJT module of FrSky Taranis transmitter. Change Mode of Module is Two
Way Mode by switchs like as this picture.
SW1: OFF SW2: OFF

2
https://furiousfpv.com
Step 2: Configure module for Transmitter:
From Home screen on your transmitter, press Menu button > Page button to go
to Model Setup page 2/12.
On Model Setup page 2/12, press ADD or Minus button more times to go to:
-Internal RF: at Internal RF we stay Mode press Enter >press ADD or Minus
change to OFF for turn OFF Internal Module.
After that, we go to External RF
-At External RF, we stay Mode press Enter > ADD change OFF to PPM.
-Turn Off transmitter.
Your transmitter had configuration look like this picture.
Now we will Bind Acrowhoop V2 with Taranis use external module Frsky DJT.
Step 3: Active Bind mode for Acrowhoop V2:
Plug Battery 1 cell for FC Acrowhoop v2.
Hold Bind button while you plug battery, when you plug Battery at the Top Side
you will see BLUE LED turn on.

3
https://furiousfpv.com
After plug Battery release Bind button.
Step 4: Bind transmitter with Acrowhoop:
Binding is the process of uniquely associating a particular receiver to a transmitter
module. A transmitter module can be bound to multiple receivers (not to be used
simultaneously). A receiver can only be bound to one transmitter module. Follow
the steps below to finish the binding procedure.
1. Turn on the transmitter while holding the F/S button on the DJT module (see
Mode and Compatibility table above). Release the button. The RED LED on the
DJT module will flash and GREEN LED ON , indicating the transmitter is ready to
bind to the receiver.
When BLUE LED on FC turn off, successful bind.
2. Turn off both the transmitter and the Acrowhoop.
4. Turn on the transmitter and plug battery for Acrowhoop. The BLUE LED on the
Acrowhoop indicates the Acrowhoop is receiving commands from the transmitter.
The Acrowhoop/transmitter module binding will not have to be repeated, unless
one of the two is replaced