Furniture of America CM-BK131AW User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-04-24
Page 1 of 15
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
CM-BK131PWCM-BK131AW
Phillips Screwdriver
(Not Included)

Page 2 of 15

Page 3 of 15
Due to the size and/or weight of this product, it is highly recommended that
the assembly should be done near the area of its intended location. Make
sure you have enough space to move around during the assembly.
ALWAYS have at least two people to help with transporting and assembling
the product to avoid any potential injury and/or damage.

Before you begin, please read Page 2
of “Assembly and Care Advice” AND
Page 9 of “Safety Warnings”.
And remember, do not tighten until
each step is completed or instructed.
Page 4 of 15
MD
BOOKCASE DIAGRAM
STEP 1: BOOKCASE ASSEMBLY
Turn right (clockwise) to tighten
Enlarged

Page 5 of 15
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
STEP 2: BOOKCASE ASSEMBLY
Enlarged
STEP 3: BOOKCASE ASSEMBLY
Enlarged

Page 6 of 15
STEP 4: BOOKCASE ASSEMBLY
STEP 5: BOOKCASE/CHESTASSEMBLY
Enlarged
Enlarged
Turn right (clockwise) to tighten

Page 7 of 15
LOFT HOUSE DIAGRAM
STEP 6: LOFT HOUSE ASSEMBLY

Page 8 of 15
STEP 8: LOFT HOUSE ASSEMBLY
STEP 7: LOFT HOUSE ASSEMBLY

Page 9 of 15
STEP 10: LOFT HOUSE ASSEMBLY
STEP 9: LOFT HOUSE ASSEMBLY

Page 10 of 15
STEP 12: LADDER ASSEMBLY
STEP 11: LOFT HOUSE ASSEMBLY

Page 11 of 15
STEP 14: LADDER ASSEMBLY
STEP 13: LOFT HOUSE ASSEMBLY

Page 12 of 15
STEP 15: LOWER BED ASSEMBLY
LOWER BED DIAGRAM

Page 13 of 15
STEP 17: LOWER BED ASSEMBLY
STEP 16: LOWER BED ASSEMBLY

Page 14 of 15
STEP 18: LOWER BED ASSEMBLY
ASSEMBLY IS COMPLETED
Read and follow the information on
the WARNINGS shown on the end
structure of the upper bunk and on
the carton. Do not remove warning
label from the bed. Keep these
instructions for future reference.
Safety is ALWAYS the main priority. For
extra safety measure and before using the
bunk bed, please take the time to inspect
the assembly and FULLY tighten every bolt
and screw from Step 1 to Step 17.

Page 15 of 15
Safety Warnings for Bunk Beds
1. Read and follow the information on the WARNINGS shown on the end
structure of the upper bunk and on the carton. Do not remove warning label
from the bed. Keep these instructions for future reference.
2. Always use the recommended size mattress or mattress support, or both, to
help prevent the likelihood of entrapment or falls. Depending on whether
you have twin, full or both sizes, the proper mattress size for the UPPER
TWIN-SIZE bunk should be 74” to 75” long x 37½” to 38½” wide x 6” high
(no higher than 6”) OR for the UPPER FULL-SIZE bunk should be 75” long
x 54” wide x 6” high (no higher than 6”). The proper mattress size for the
LOWER TWIN-SIZE bunk should be 74” to 75” long x 37½” to 38½” wide x
6” to 8” high OR for the LOWER FULL-SIZE bunk should be 75” long x 54”
wide x 6” to 8” high.
3. Surface of mattress must be at least 5 inches (127 mm) below the upper
edge of guardrails.
4. Do not allow persons under 6 years of age to use the upper bunk.
5. Periodically check and ensure that the guardrails, ladder, handle and other
components are in their proper position, free from damage, and that all
connectors are tighten and secured.
6. For safety reasons, especially on the upper bunk bed, DO NOT allow rough
playing or jumping on the bed and do not allow playing or hiding under the
bed.
7. Always use the ladder for entering and leaving the upper bunk.
8. Do not use substitute parts. Contact the manufacturer or dealer for
replacement parts.
9. Use of a nightlight may provide added safety precaution for a person using
the upper bunk.
10. Always use the guardrails on both long sides of the upper bunk. If the bunk
bed will be placed next to the wall, the guardrail that runs the full length of
the bed should be placed against the wall to prevent entrapment between
the bed and the wall.
11. The use of water or sleep flotation mattresses is prohibited.
12. No more than one person is allowed on the upper bunk at all times.
13. The MAXIMUM weight capacity for the upper bunk is not to exceed 150 lbs.
.WARNING:
STRANGULATION HAZARD
Never attach or hang objects to any part of the bunk bed that are not
designed for use with the bed. Objects such as hanger, hook, belt,
bag, rope, string, etc. should not be used on or around the bunk bed.